A Cutlass is more or less the same thing as a Malibu or Monte Carlo. You could use motor mounts from either of those.
the big block will bolt right to the small block motor mounts but they do make big block motor mounts that you can buy and install on the 66, it lets the engine sit a little lower and further to the drivers side.
small block and big block motor mounts are the same, so you should be able to take V8 motor mounts from most any Chevy engine bay.
The small plugs, on both sides of the engine block, at the rear edge of the motor mounts. A pita to drain. You have to remove the motor mounts.
NO. Not even close.
Carefully place a jack with a block of wood under the motor, loosen mounts from motor, jack motor up just enough to remove old mounts, replace mounts, lower motor onto new mounts, tighten motor to mounts. Make sure there aren't any hoses, wires, lines, etc. that may tear while lifting the motor.
Carefully place a jack with a block of wood under the motor, loosen mounts from motor, jack motor up just enough to remove old mounts, replace mounts, lower motor onto new mounts, tighten motor to mounts. Make sure there aren't any hoses, wires, lines, etc. that may tear while lifting the motor.
no
externally, they are the same. The engine mounting holes on the block are the same. the motor mounts themselves might be different though.
yes but you will have to use motor plates to install it in place of motor mounts.
change the motor mounts and get the computer and wiring harness out of the donor car that the small block came out of.
Yes, a 283, 305, 307, 327 etc will fit. You should be able to use small block motor mounts from 1966
Transmission mounts are they considered motor mounts? After saying that how many motor mounts do I need to replace, if I change out all of them.