both are same using for rotating the turbine initially
You don't start a large turbine cold. Typically, the lubrication system is started, the turning gear is engaged and warming steam (a small amount of steam, not enough to turn the turbine) is admitted to the turbine to warm and initially expand the shaft and casing. If this isn't done, thermal shock from the admission of high pressure superheated steam into the cold turbine could damage it.
So you can tell if the motor is turning (running) just by looking.
You rip apart an atom which releases great energy in the form of heat. The energy causes water to evaporate which turns a turbine. The turning turbine creates electricity. This is how a nuclear reactor works.
Gas turbines are a type of Internal Combustion engine, however; Assuming that you want to know the difference between a recpirocating piston engine and a gas turbine engine, the simple answer is that ICE's (Internal combustion engines) create work by moving a crank that is connected to a piston. An explosion in the piston chamber pushes a piston (or series of pistons) attached to a crankshaft, which turns the shaft. The gas turbine works by turning a shaft connected to a turbine. The turbine is powered by a compressed feul-air mixture. A stream of gas is compressed with air and forced through a chamber containing the turbine. The turbine turns the shaft as a result of complex mechanics that control the movement and flow of the compressed fuel-air mixture. The basic mechanical difference: A reciprocating piston engine uses a linear "back and forth" motion to turn a shaft, and the gas turbine engines relies on a constant circular motion to turn a shaft.
On a pedestal drill the workpiece is static and the drill is in a vertical position and rotates. On a lathe the workpiece rotates but not the drill, and the drill is in a horizontal position.
There is no difference between a turning machine and a lathe. They are two names for the same kind of machine
different between twist and turn
electricity created by the flow of water turning a turbine
Basic difference between turning and milling is that , In turning the tool is fixed and the job rotates whereas in milling the job is fixed and the tool rotates
from mechanical to electrical
A turbine is most commonly connected to a generator to produce electricity. The turbine may be turned by water falling into it, and a generator produces electricity by turning through a magnetic field.
kinetic energy into electric energy
generally , cranking an engine is done with igniton where turning is done by hand with the ignition off so as it will not start
Turning off it stays off until you turn it on, restart just automaticlly turns off then back on.
Nutrition is getting food, respiration is turning the food into energy
Whatever is turning the shaft (turbine, motor, hand crank, etc.).
Alp u know the answer. anyway its called turbine.