service lateral conductors are the underground conductors between the utility electric supply system and the service point, basically the cables that bring power from the transformer to the power meter in an underground service
A #1 copper conductor with an insulation rating of 90 degrees C is rated at 145 amps.
A conductor used for grounding of the main service should be a single wire. The code book has a table that states the size of ground wire for different service panel amperages.
In a service drop conductor the only limiting factor is the first over current device down stream from the service.
From the question it is hard to establish whether the service size is 350 amps or the service conductors are 350 MCM in parallel. If the service is 350 amps, the grounding conductor is #3 bare copper wire. Parallel 350 MCM conductors will allow for a 600 amp service. The grounding conductor for a 600 amp service is a #1 bare copper wire.
A 3/0 copper conductor with an insulation factor of 90 degrees C is rated at 225 amps.
For service sizes of 100 amps and less a #8 bare copper conductor is required.
Answer for USA, Canada and countries running a 60 Hertz supply service.CEC states that a #3 bare copper conductor is a common grounding conductor size for a 200 amp service panel and it is the minium size for service raceway and service equipment of 400 amps.
A #1 copper conductor with an insulation rating of 90 degrees C is rated at 145 amps.
A conductor used for grounding of the main service should be a single wire. The code book has a table that states the size of ground wire for different service panel amperages.
wewhacku@webmail.co.za
The most commonly used conductor of electricity is copper. For larger size service conductors the most commonly used conductor for electricity is aluminum. Aluminum service conductors are used to keep the overall cost of the project lower and are lighter to work with than copper wire.
In a service drop conductor the only limiting factor is the first over current device down stream from the service.
From the question it is hard to establish whether the service size is 350 amps or the service conductors are 350 MCM in parallel. If the service is 350 amps, the grounding conductor is #3 bare copper wire. Parallel 350 MCM conductors will allow for a 600 amp service. The grounding conductor for a 600 amp service is a #1 bare copper wire.
A 100 amp residential service requires a size #8 copper wire, it should be insulated in green.
A 3/0 copper conductor with an insulation factor of 90 degrees C is rated at 225 amps.
It is the conductor that is used in service distribution panels that bonds the distribution panel's neutral bus bar to the ground electrode (rod). This brings all of the distribution panel neutrals that are connected to the same supply system to the same potential, that being zero. Should a supply service neutral open this ground wire will maintain the systems integrity until repairs can be made.
This can't be answered without knowing the voltage, and ground is not the same as neutral, in AC circuits, which I'm assuming this is.