It is another name for a porcelain lamp holder. You don't see many porcelain ones any more they are now made of plastic. They are ceiling mounted and a bare light bulb just screws into them.
A fixture is what the light bulb goes into.
The light is wired the same as any voltage fixture. Bring the source voltage to the fixture and connect it to the two fixture wires. If you want to control the off-on of the fixture take the source voltage to a switch first and then out of the switch to the light fixture.
Disconnect the fixture wires and remove the central mounting nut to release the dome from the light fixture in a ceiling fan.
It just holds the bulb, does not have a switch in the fixture.
A lock is a fixture, same as a light, sink, tub. A fitting is usually a part of a fixture, or a fixture is made up of fittings.
No, they are not designed to be used outside and can only be used inside.
A fixture is what the light bulb goes into.
The correct spelling for a fancy light fixture is "chandelier."
The light is wired the same as any voltage fixture. Bring the source voltage to the fixture and connect it to the two fixture wires. If you want to control the off-on of the fixture take the source voltage to a switch first and then out of the switch to the light fixture.
Take the nut off at the bottom of the light fixture by unscrewing it.
Inside the dome light fixture. Slide it forward about 2 inches and it will drop off the clips. Control module is mounted inside the cover.
Disconnect the fixture wires and remove the central mounting nut to release the dome from the light fixture in a ceiling fan.
It just holds the bulb, does not have a switch in the fixture.
A lock is a fixture, same as a light, sink, tub. A fitting is usually a part of a fixture, or a fixture is made up of fittings.
If the question is, can I wire a switch to an existing light fixture (and I must assume that it's something like a pull-chain light fixture), the answer is yes.If the question is, "how do I wire a switch to an existing light fixture that has no external switch", the answer is, "in series".The attached web site gives simple instructions on how to wire a basic light switch to an existing light.See sources and related links below
A fixture or device that holds a light in place by means of some sort of socket, that is connected to a power source.
The tail light lens on a 1989 Chevy Celebrity is part of the tail light fixture and cannot be conveniently removed. If you want to change a light bulb you have to remove the tail light fixture from the car. To remove the tail light fixture: 1. In the trunk next to the quarter panel are three nuts, remove the center nut. It should be in the center of the tail light fixture. 2. Pull the tail light fixture so that the stud comes out of the body, then pull outward to pull the tab out of the backup light fixture. 3. You can now take the appropriate socket out and replace the bulb. Reverse the steps to replace the light fixture.