0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you tell rear end ratio on 1978 Chevy truck?
To know for sure, You need to remove the big metal plate on the rear end housing and count the # of teeth on the BIG round gear / Ring gear. Then count the teeth on the small round gear / pinion gear that sets deep in the housing and runs on the big gear. Then divide the small # into the high # and that will be you gear ratio.
Where is the speedometer gear located inside a 73 350 transmission?
The drive gear is in the tail shaft of the transmission. The driven gear is on the end of the speedometer cable housing.
Why does Peugeot 307stall changing down from 3rd gear to 2nd you recently had a clutch fitted?
Check manifold housing and inner rubber housing of gear near timing belt. Peugeot parts and assembly pathetic.
How do you get a speedometer gear that fell into the transmission out?
I don't know what year, make or model you have but most transmissions have the speedo mounted in the tail shaft extension housing so, if you remove the tail shaft housing you can retrieve the speedo gear.
Can you install a super t10 mainshaft and extension housing on doug Nash 4 3 gear box?
Yes, you can. But you would need to change a few items as well. Reverse gear and idler and mid-plate. You would also need the correct tailshaft housing and speedometer drive gear as well.
A gear housing for a tractor is to be sand cast which metal will be used gray casting or stell?
steel
How do you change the gear stick gator on xsara Picasso?
it is only clipped into the housing and you just have to pull it out
How do you fix the speedometer on a 1993 Isuzu Rodeo?
I have the same problem with my 1995 Rodeo. I lost the speedometer and had a bit of a learning curve. I replace the speedometer gear and it work well for a few days and went out again. It cost about 45 dollars, (For the Gear) I was kicked out of a Isuzu dealer when I went back and talked to a mechanic about the problem. Luckily I managed to get the answer before I was asked to leave. He mentioned that the gear housing also need to be replace at the same time as the new gear. The reason being that it creates it's own type of wear in the housing. Being that the housing was metal I was bracing for the worst. I was shocked when the metal housing was 22 bucks. The other shocker was that I changed it out just out side the dealership. Its very easy to do, one bolt and it drops right down. I placed the new gear in and then the metal housing and was back on the road in less than 10 min. So the answer to the question is you need to replace the housing and gear at the same time! I was shocked that it worked fine after I replaced the metal housing that holds the gear in place. I hope this works well for you, it worked fine for me. PS. I tried a junk yard part first and had problems, buy new its cheaper. Best of luck Paul.
Where is the Speed sensor for a 96 trans am?
In the transmission tail housing where the speedo gear would be in an older version.
Will it hurt the transmission if you don't fix the speedometer?
No. Several Things Go Wrong With Speedometers. Cable Break, Plastic Gear In The Back Of Speedometer Housing, Or In The Housing Of The Transmission. But No It Will Not Hurt The Transmission.
What is the plate called that holds the starter on a f250 power stroke diesel?
starter motor is mounted into the front of the bell housing this is also where the bolts to secure the starter go if there is a plate between starter and bell housing, it is a spacer to give correct clearance of starter gear and ring gear teeth
How do you replace the abs gear that the sensor reads on 2005 ford escape?
Gear is part of the outboard CV jount housing and is not separately replaceable. Geberally entire shaft known as halfshaft is replaced.
