Well, I just figured out why my Toro Weedwacker wouldn't run, The fuel hoses were backward, My brother had it for a while then told me it stopped running. He apparently tried to FIX it but accidentally reversed the fuel lines so.
1. Fuel comes out of the tank and goes directly into the bottom of the Carb,
2. Fuel is pulled through the carb from the side tube on the carb into the priming bulb.
3. Once the priming bulb is full the fuel is then returned directly to the tank through a hose which protrudes into the tank about 2 ".
4. Ran fine after I got the hook up correct.
Make sure you have the lines wright the skiney line from in the tankgoes to the top nipple on the carb the over flow line goes to the long nipple on the primer bulb and the other line off the primer bulb goes to bottom nipple on carb
flow to
in which direction does the river Shannon flow?
Disconnect the input side of the "fuel water separator" (Fuel filter) take that hose and connect it to another long 1/4 inch hose with a primer bulb on the other end. Get the primer bulb lower than the gas tank of the jetski and start the flow by squeezing the bulb. Make sure you have the jetski gas selector in the "RES" position to get as much out as possible. Once it starts flowing gravity should do the rest. It's not fast but it works.
Blood flow doesn't change direction. They always head for the same direction.
Downward, Downriver, Downhill, the direction gravity pulls everything.
The electrical current comes into the bulb from the metal side,flow through the filament ,and out the tip.
The direction of lymph flow is always towards the Thoracic Lymph duct .
These are machines dealing with fluids, like (Axial Compressors, pumps and Fans). the term "Axial" is given due to the direction of inward and outward flow. In axial turbo machines the direction of outward flow is the same as the direction of the inward flow since the blades of the machines doesn't change the direction of flow.
Diodes convert AC into DC by allowing current flow in one direction only. Since AC is alternating between plus and minus it is not possible to use a diode to allow AC to flow in one direction and not in the other direction.
Electro motive Force(E.M.F) of a battery determine the direction of Flow of Charges.
When the flow of current is aways in one direction it is known as direct current.