torque settings for a vauxhall 1.7 td clinder head
torque settings for mains,big ends and cylinder head Opel Corsa 1.7diesel 2000
think its number 36
The cylinder head torque settings for a Land Rover 300 DTI starts at 40Nm for all bolts. Then for M10 x 117 mm long 60 degrees, M12 x 100 mm long 60 degrees.
chain usually
If the alternator was recently replaced on an Astra DTI 1.7, then there is a good chance that the power steering pump is not working properly because the serpentine belt is too loose or too tight. Check the belt and either tighten or loosen the tension pulley.
the size is 20 inch max but i prefer 19 inch with think tyres
The 2001 Vauxhall Astra DTI typically has a timing belt, which is often referred to as a cam belt. It's essential to replace the timing belt at recommended intervals to prevent engine damage. Always consult the owner's manual or a professional mechanic for specific maintenance guidelines regarding your vehicle.
100,000 miles on 1.7 dti or cdti engine
hi there my glow plugs are needing changing i think, problems starting, but cant get in to get them off. Could you help me with this please.
On a 1.7 DTI Astra van, the frost plugs, also known as core plugs or freeze plugs, are typically located on the engine block. They can be found on both the left and right sides of the engine, usually near the cylinder head. Their primary function is to prevent coolant from freezing and causing engine damage. When troubleshooting or inspecting, it's important to check for signs of leaks or corrosion around these plugs.
Rattling under load in your Astra 1.7 DTI could be caused by several factors. Common culprits include worn engine mounts, which can allow for excessive engine movement, or loose exhaust components that vibrate under stress. Additionally, issues with the turbocharger or fuel delivery system might contribute to the noise. It's advisable to have a mechanic inspect these elements to pinpoint the exact cause.
Open up your fuel cap and have a look on the inside. It will tell you how much pressure you need in K/sm and psi.