torque settings for a vauxhall 1.7 td clinder head
torque settings for mains,big ends and cylinder head Opel Corsa 1.7diesel 2000
think its number 36
The cylinder head torque settings for a Land Rover 300 DTI starts at 40Nm for all bolts. Then for M10 x 117 mm long 60 degrees, M12 x 100 mm long 60 degrees.
chain usually
If the alternator was recently replaced on an Astra DTI 1.7, then there is a good chance that the power steering pump is not working properly because the serpentine belt is too loose or too tight. Check the belt and either tighten or loosen the tension pulley.
the size is 20 inch max but i prefer 19 inch with think tyres
100,000 miles on 1.7 dti or cdti engine
hi there my glow plugs are needing changing i think, problems starting, but cant get in to get them off. Could you help me with this please.
Open up your fuel cap and have a look on the inside. It will tell you how much pressure you need in K/sm and psi.
check manufacturers recommendations Chain driven engine, should never need doing.
Crank sensor is best viewed from under car,its above offside drive shaft and a pain to get to,held in with 1 torx bolt
Tagalog translation of DTI: Kagawaran ng Kalakalan at Industriya