0
These are capacitors that are connected in a circuit in parallel with the load. A circuit with low, lagging (inductive) power factor (pf) can be improved by those static capacitors by decreasing the circuit's inductive reactive power (wasted power consumed for magnetic induction of motors) reducing it's pf to almost unity (1).
A circuit with low power factor means it consumes more power which is actually not being used or wasted. Putting a static capacitor for pf correction improves the circuit.
CommentPower-factor improvement doesn't 'improve the circuit', and it has no effect on the power of a load, it merely reduces its load current.
Wiki User
∙ 12y ago
Wiki User
∙ 8y agoCapacitor is an electronic component that stores electric charge. The capacitor is made of 2 close conductors (usually plates) that are separated by a dielectric material. The plates accumulate electric charge when connected to power source. One plate accumulates positive charge and the other plate accumulates negative charge.
The capacitance is the amount of electric charge that is stored in the capacitor at voltage of 1 Volt.
The capacitance is measured in units of Farad (F).
The capacitor disconnects current in direct current (DC) circuits and short circuit in alternating current (AC) circuits.
Add your answer:
Earn +20 pts
Whether film capacitors can be replaced with ceramic or mica capacitor?
Film capacitors cannot be replaced with ceramic or mica capacitors if used for analog signal processing. However, mica capacitors can be replaced with ceramic capacitors in general.
Why do capacitors leak?
Mostly the leakage of capacitors is due to the resistor.
How many capacitors are use in a circuit?
Capacitors store charge. There are many applications for their use. There is no set amount of capacitors in a circuit since it is application dependent.
Active component in resistors and capacitors?
Resistors, capacitors, inductors, diodes are all passive components.
Why are capacitors required to be in capacitor banks?
Capacitor banks are used to control the power factor in a power system. By connecting suitable capacitors the power factor can be controlled / maintained at a desired level. The requirement of a capacitor changes as the load changes dynamically. The same amount of capacitors can not maintain the desired power factor all the time. To be able to connect only the required number of capacitors, multiple (bank of capacitors) capacitors are included in a system. An automatic controller senses the actual power factor and connects and disconnects the capacitors from the bank as required
What is a static ram and dynamic ram?
static RAM:It is composed of registers ,which loses its content when power is switched off.dynamic RAM:It is composed of capacitors,which is a charging and discharging in nature.
Are capacitors polarity sensitive?
The capacitors those are polarity sensitive are called electrolytic and tantalum capacitors. These capacitors are labeled as positive and negative.
How are capacitors rated?
Capacitors are rated in Microfarads
What is the difference between electrolytic capacitors and normal capacitors?
because normal capacitors does not have any polaririties.
Whether film capacitors can be replaced with ceramic or mica capacitor?
Film capacitors cannot be replaced with ceramic or mica capacitors if used for analog signal processing. However, mica capacitors can be replaced with ceramic capacitors in general.
Which ram is faster static ram or ddr ram?
Static RAM is fasterAnswerStatic Ram, SRAM Is Cache memory and Dynamic Ram, DRAM is main memory.Dynamic Ram consists of one transistor and two capacitors there for this needs to be constantly refreshed there for slower than static ram as for Static Ram this has 6 transistors which deal in transistor 1's and 0's on and off's this means it does not need to be refreshed there for much faster than dynamic ram Static Ram sits between the central processing unit and the main memory.
How can you stop Television from humming?
Replaced capacitors that are no lomger capacitors.
What is the population of Nokian Capacitors?
Nokian Capacitors's population is 290.
When was Nokian Capacitors created?
Nokian Capacitors was created in 1957.
Why do capacitors leak?
Mostly the leakage of capacitors is due to the resistor.
What are the applications of power electronics in utility?
Used in HVDC for rectification and in inverters. Used in variable speed drives, static switches for PFC capacitors. There are alot more and the application of power electronic devices is growing rapidly.
What did people use the first battery for?
In 1749, Benjamin Franklin first used the term "battery" to describe a set of linked capasitors he used for his experiments with electricity. These capacitors were panels of glass coated with metal on each surface. These capacitors were charged with a static generator and discharged by touching metal to their electrode. Linking them together in a "battery" gave a stronger discharge.
