answersLogoWhite

0


Best Answer

The distributor should face forward rather than backward on the Chevy 350. It is important to mark the front face of the distributor before removing it.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Should the distributor face forward or backward on a Chevy 350?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would a 2003 Chevy impala roll backward in drive and forward in reverse when on inclines?

Weight of the vehicle


What position should the plug on the distributor be in at TDC on a 4.3 Chevy?

The rotor inside the distributor should be pointing at the #1 spark plug.


How do you change a distributor on a 98 Chevy Silverado?

how to repace the distributor on an 98 chevy silverado


Does a 1999 Chevy s10 pickup with a 2.4 engine have a distributor cap?

That should be a 2.2 engine and no, it does not have a distributor cap. It has a DIS (Distributorless Ignition System).


Where the distributor on a 1994 Chevy sliverado 1500?

it should be right behind T.B.I unit....just follow your spark plug wires from block to..distributor and there it is....


Can you use a 72 coil on a 92 Chevy distributor?

If the coil looks the same you should be able to use it and only if the coil isn't mounted in the distributor.


What is the distributor setting for a 1996 Chevy Blazer 4.3 V6?

what is the distributor setting for a 1996 Chevy blazer


Will a Chevy HEI distributor replace a pontiac points distributor?

no


How do you reinstall a distributor on a 1998 Chevy Astro van?

how reinstall a distributor on a 1998 chevy astro, and faun time


Does a 97 Chevy Cavalier have a distributor cap?

Yes, a 1997 Chevy Cavalier does have a distributor cap. The distributor does not have points and a condenser. This part is one electronic unit.


Where is the camshaft position sensor located on a 98 Chevy truck 454 engine?

It should be part of the distributor.


What is the point gap for a 1979 Chevy 292?

A 79 shouldn't have points to gap. It should be an HEI distributor.