answersLogoWhite

0


Best Answer

Switch or the park switch in the motor.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Rear wiper on 1998 Chrysler van runs all the time?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Refill rear window wiper fluid Pontiac Vibe?

I am pretty sure it runs off of the same fluid as the fronts. There should be a clear plastic tube running down the passenger side of your car which carries it from the reservoir in the engine bay back to the rear wiper.


Mercury villager rear wiper motor runs all the time?

You may want to try removing the wiper blade and shaft nut first to eliminate the blade from continually moving. Then, consult your mechanic.


Is the Oldsmobile Delta 88 1998 a rear wheel drive?

A 1998 Oldsmobile Delta 88 is a rear wheel drive car. This means that a drive shaft runs from the back of the transmission to the rear axle to transfer power.


Where is the fuse for the cruise control on 1998 Chrysler Town and Country van?

The cruise control is powered by the engine computer. If the engine runs, the fuses are ok.


When should you change the windshield wiper fluid?

When it runs out!


Why does your radio stay on when you turn your Chevy Astro off and when vehicle is running radio runs with no fuse and loses power when you use your rear hatch release button or rear wiper?

Also there doesn't seem to be enough power going to the back hatch release or the wiper to operate. Had at one time the whole dash went out then came back while idling. Van is a 93.


What are the small shocks that run at an angle on rear of 1998 Ford Explorer?

On a 1998 Ford Explorer ( same as my 1995 ) Ford calls the smallrear shock absorber that runs on an angle the ( rear axle differential shock absorberor lateral shock ) As far as I can figure it is used to stabilize the rear differential ( P.S. I'm not a mechanic / technician )


The rear wiper motor for your 1997 Jeep Wrangler Hardtop has three wires When you connect only two to a switch you are able to operate the wiper Why are there three wires?

The three wires are the ground wire, the hot wire that runs through the switch and is energized only when the switch is in the on position and the third wire which is energized anytime the ignition switch is on. This circuit allows the wiper arm to go to the "park" position when you turn the wiper switch off. If you turn the ignition switch off while the wiper is in operation it will stop immediately and not continue to the "park" position. When the ignition switch is turned on again, the wiper will return to "park".


Wiper blade do not move but motor runs?

Look for a broken linkage going from the wiper motor to the wiper arms. Also check to see if the nuts holding the wiper arms are loose, that is one of the most common problems, but usually only affects one wiper arm at a time.


What kind of fuel does the 2009 Chrysler 300 use?

The 2009 Chrysler 300 runs on regular unleaded.


What kind of fuel does the 2008 Chrysler 300 use?

The 2008 Chrysler 300 runs on regular unleaded.


What kind of fuel does the 2007 Chrysler 300 use?

The 2007 Chrysler 300 runs on regular unleaded.