0
my question i primed my 1984 chev new 350 5.7 from the distribuator only got oil on all the valves on the passanger side none on the passanger side why
I don't think you have anything to worry about. It's probably just a case of not spinning the pump fast enough to push oil down both sides of the oil galley. If you have pressure on the gauge when spinning the pump, go ahead and finish up the installation.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What are the symptoms of low oil pressure on a 1982 Chevy 350?
Engine noise.
Is there a oil level sensor to shut down the engine due to low oil on a 1997 Chevy Suburban 350?
no, but its not a good idea to let oil get low
What causes low oil pressure in rebuilt 350 Chevy?
Not sure, i would say oil pump or cam bearings
What are symptoms of oil pump going out on a 2000 Chevy Tracker?
low oil pressure if you have a guage instead of a light and usually accompanied by valves ticking showing the need for more oil.
Why does a Chevy 350 oil pressure gauge bounce now and then?
A mechanical oil gauge may bounce if you are low on oil. An electric oil gauge may bounce if the sending unit or the gauge itself is faulty and of course you are low on oil.
Is there an oil pump gasket for a Chevy 350?
no
How much oil does a 1976 Chevy 350 hold?
1976 Chevy 350 engine should take 5 qts engine oil with filter change.
Where do you install the oil pressure gauge on a Chevy 350 small block?
how to install the oil pressure gauge on a Chevy 350 small block
What Chevy 350 parts are interchangeable with Chevy 454?
The distributor and the oil filter.
Where is the oil plug on a 1994 Chevy 350?
The oil drain plug on a 1994 Chevy 350 is on the underside of the motor. Look for a bolt in the very center of the bottom of the engine.
What kind of oil do you use in a 1995 Chevy 350 engine?
5W30 oil.
What is happening when Chevy 350 1994 burns oil and valves are good?
if you get blue smoke only when you start it the valve seals are bad. if it blows blue all the time. the piston rings are bad.
