2000 PONTIAC SUNFIRE 2.2L 4-cyl & 2000 PONTIAC SUNFIRE 2.4L 4-cyl
CAPACITIES
Engine, without filter..........4.0 quarts [1]
Cooling System, Initial Fill..........11.0 quarts
AMSOIL Antifreeze and Engine Coolant
Automatic Transmission, 125 (3T40) Initial Fill..........4.0 quarts [2]
Automatic Transmission, 4T40E,-45E Initial Fill..........6.9 quarts [2][3]
Automatic Transmission, Total Fill
3 speed 3T40..........9.0 quarts
4 speed 4T40E..........13.0 quarts
3 speed THM125..........9.0 quarts
Manual Transmission, ..........3.6 pints [4]
1. Add extra oil when replacing filter. Refill check oil level.
2. With the ENG at operating TEMP, shift TRANS through all gears. Let ENG slow idle in PARK for at least 3 minutes. Check fluid level and add fluid as needed. Do not overfill.
3. 4-Speed transaxle does not have a dipstick. Fluid should be be at the level of the fill plug located at the lower right of the passenger side driveshaft.
4. Identification: Isuzu has a 7-bolt aluminum end cap, Muncie has a 9-bolt steel end cap.
TORQUES
Oil Drain Plug.....33 ft-lbs
Manual Transmission 5-SPD Muncie
Drain Plug.....18 ft-lbs
Manual Transmission 5-SPD Getrag
Drain Plug.....18 ft-lbs
Manual Transmission 5-SPD NV
Drain Plug.....18 ft-lbs
2000 PONTIAC SUNFIRE 2.2L 4-cyl
FILTERS
Amsoil Oil Filter......EAO29
Wix Oil Filter.........51040
Amsoil Air Filter......EAA86
Wix Air Filter.........46503
Wix Fuel Filter........33311
Wix Trans Filter.......58611 [1]
Wix Trans Filter.......58952 [2]
1. 4 Speed
2. 3 Speed
2000 PONTIAC SUNFIRE 2.4L 4-cyl
FILTERS
Amsoil Oil Filter....EAO32
Wix Oil Filter.......51042
Amsoil Air Filter....EAA86
Wix Air Filter.......46503
Wix Fuel Filter......33311
Wix Trans Filter.....58611 [1]
Wix Trans Filter.....58952 [2]
1. 4 Speed
2. 3 Speed
Check oil level, oil filter, oil pump.
An oil can with 3 little drips
I gather you speak of a 2-stroke and a name brand 50:1 two cycle oil will suffice.
If you have 100 kilos of oil in a sealed can and you cool it or warm it, the weight of the oil will not change. However the volume of the oil in the can will change.
108cdi takes 7.5 lt of oil
10w30
first i would try the oil pan
it is located inside the oil pan.
the oil pump is located inside the oil pan housing.
4.5 quarts
Try under the oil cap, oddly enough.
Remove the transmission oil pan
just above the oil filter
It has a capacity of 4 quarts.
A 4 cylinder takes 4 and 1/2 quarts
Approxiamtely 4 litres.
Yes. Actually, this is becoming the new standard weight oil in much of the US.