20 foot pounds
21 ft pounds
torque for 2c engine cylinder head bolts
You should torque the head bolts by alternating from and to end, working towards the center. The head bolts should be torqued in 40 pound intervals.
No, head bolt torque is much higher than rocker arms.
Torquing head bolts without a torque angle meter is substantially harder than with one but it is very much possible. All it requires is keeping a steady hand and a keen eye on your work.
65 ft lbs.
I need answers
33ft.lbs then 90 degrees
TUD5 engine head torques Stage 1. 40NM Stage 2. + 260 degrees Maximum head bolt length is 197mm.
Head Bolts for a VW 1600 Dual Port is m10 nuts = 23 ft. lbs. and the m8 nuts = 18 ft. lbs.
i have a 4d32 deisel engine i change the cylinder gaskit i need to know how much foot pound to torque the bolts
Proper way to torque them is to buy new bolts and do them up via instructions that come with head gasket ( they are torque to yield - from mem 30 ftlb then 180 degrees more , but that's just from mem ). If you are not using new bolts you are better off to just do them to about 40ft lb, 50 , then 65ft lb .Not much use toqueing to yield unless you use new bolts...