0
2.0 dohc is set with selective shim fit
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you set the valve lash on a 3.1 L Chevy Malibu?
There is no setting....they are torqued to 20 foot pounds.
How do you set valve lash on a 1969 Pontiac fire bird 5.7?
There is no lash adjustment on Pontiac engines. You simply torque the nuts down to 20 foot lbs.
Valve adjustment on 95 lumina?
This vehicle is equipped with hydraulic valve lifters that do not require adjustment. They are set at zero lash by tightening the rocker arm nuts to 14-20 ft. lbs. If you hear a little valvetrain noise coming from your 3.1L engine, this is normal.
How do you adjust 94 Oldsmobile 3.1 valve lash?
These are non adjustable. They simply torque down to 20 foot pounds.
How do you clean an egr valve on a 2001 Mazda tribute v6?
Your best bet it to simple replace it... they are under $20, and they are really easy to do..
What are the release dates for The Law's Lash - 1928?
The Law's Lash - 1928 was released on: USA: 20 May 1928
How much does it cost to get a lash extension?
It is not expensive to get lash extensions. It can cost between $5 and $20 depending on where you go to get them.
How do you tell if you have a burnt valve on a 1994 ford ranger 4.0?
use a compression tester you can buy one from any auto parts store for around 20 bucks ...I just had a burnt valve on my 1999 Mazda b3000
Can you fit 20 inch rims on a Mazda 626?
can 20 " RIMS FIT ON A MAZDA 626?
Where is the cam sensor located on a 2001 Mazda protege es 20?
The cam sensor is located on the left side of the engine (as your looking at it) on the valve cover. It is the only sensor that is located on that side on the upper part of the engine.
How do you replace the ERG valve in a Mazda Tribute?
purchase it with a gasket and replace it but it doesn't work some time if you looking forward to kill your check-engine light. The Mazda Tribute ecu has to relearn/ reprogram itself(1)You could take your vehicle to the nearest Mazda dealer get your computer "flashed". (2) you could reset Your ecu by using a obt2 code reader.(3) you must drive your vehicle For 20 minutes for your ecu to relearn its readings from the new egr valve/sensor.............."BUKUBU!LT" B I G Island HAWAII
Where is the heater control valve in a g-20 Chevy van?
Where is the heater control valve for a 93 Chevy van, G-20, 5.O
