How do you program the garage door opener on a Volvo S80?

Answer 1

Homelink Garage Door Opener (long) S70 2000 posted by someone claiming to be Joe Montana on Mon Aug 8 20:52 CST 2005 From the 2000 S70 owners manual pg. 198 HomeLink® Universal Transceiver (option) Indicator light HomeLink® Universal Transceiver This transceiver allows you to replace 3 hand-held transmitters with a single built-in device which can be installed in your car on a sun visor or overhead console. This feature "learns" the radio frequency codes of most current transmitters to operate garage doors, driveway gates, security lighting and home security systems. This transceiver is powered by your car's electrical system. NOTE: As a security precaution, the HomeLink® Universal Transceiver is designed to not function if the car has been locked from the outside. Programming the transceiver 1. Begin by erasing all 3 factory default channels by holding down the two outside buttons (buttons 1 and 3 in the illustration above) on the HomeLink® Universal Transceiver until the indicator light on the transceiver begins to flash, after approximately 20 seconds. Release the buttons. 2. Hold the end of your hand-held transmitter 2 to 5 in. (5 to 12 cm) away from the HomeLink® surface, keeping the indicator light in view. For placement questions, please contact HomeLink® at 1-800-355-3515 (internet: www.HomeLink.jci.com). 3. Using both hands, simultaneously push the hand-held transmitter button and the HomeLink® button to be programmed. Do not release the buttons until this step has been completed. The HomeLink® indicator light will begin to flash, first slowly, then rapidly. When the indicator light flashes rapidly (indicating that the HomeLink® button has been successfully programmed), both buttons may be released. The remaining two HomeLink® buttons can be programmed in the same way. If, after several attempts, you do not successfully program the HomeLink® Universal Transceiver to learn the signal of the hand-held transmitter, refer to the section "Programming rolling codes" or call the toll-free customer assistance number: 1-800-355-3515 (Internet: www.HomeLink.jci.com). pg. 200 HomeLink® Universal Transceiver (option) After searching online, this is the answer I found. I have not tried it yet. I'll give it a try as no one has come up with an answer and it seems to conform to the available buttons on the visor. Reprogramming a single HomeLink® button 1. Press and hold the desired HomeLink® button. Do not release the button until step 3 has been completed. 2. When the indicator light begins to flash slowly (after approximately 20 seconds), position the hand-held transmitter 2 to 5 in. (5 to 12 cm) away from the HomeLink® surface. 3. Press and hold the hand-held transmitter button. The HomeLink® indicator light will begin to flash, first slowly then rapidly. When the indicator light flashes rapidly, release both buttons. The previously programmed device has now been erased and the new device can be activated by pressing the HomeLink® button that has just been programmed. This procedure will not affect any other programmed HomeLink® buttons. NOTE: · Retain the original transmitter(s) for future programming procedures (i.e., if you purchase a new car). · It is also suggested that if you sell your car, the programmed channels on the HomeLink® Universal Transceiver be erased for security purposes.