answersLogoWhite

0


Best Answer

If the trans is locked in one gear, and the stick refuses to move, it has very likely jumped out of the shift selector rods. You will likely have to remove the shift stick cross pin, to pull the stick out, and manually with a long flat screw driver, shift all rods to the neutral position. There are cut aways in the rods. The neutral position should be when they are all in the same general location so the stick can move between them. Test this by bumping the starter, before replacing the stick.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you get your Massey Ferguson to shift out of reverse it is stuck in reverse?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

If your gas pedal gets stuck while you are driving you should?

Shift to reverse


Your 1997 montero is stuck in 4 wheel drive?

Shift it on 2H, then "REVERSE" for about 10 to 15 Feet....


Mercedes clk430 gets stuck in park and won't go in reverse gearHow do I shift it into reverse?

I am not sure but there should be a switch by the brake pad to release the safety neutral switch to allow you to shift. Try that.


Mercedes cl500 gets stuck in park and won't go in reverse gearHow do I shift it into reverse?

Shifter assembly need replaced and it also need coded otherwise will not work.


How do you get a 1986 Yamaha moto-4 out of reverse it's stuck and the gear shift won't go into any gear?

use the clutch


You rocked from drive to reverse when stuck in Chevy 4x4 z71 now have no reverse and seems to be in gear in any shift mode seems like shifter is 2 holes off from normal but shift rods are normal?

sounds like selector in transmission is broken if you can move the shifter but the trans does not change you may have broken the shift cable.


Won't shift into reverse?

Type of vehicle and is it a standard or automatic? Could be shifter linkage, clutch, something stuck around the shifter. If standard, will it shift into reverse when the engine is off? If so, it is most likely the clutch slave cylinder. Could be the master cylinder, but the slave usually goes bad first.


Why would a 2002 polaris sportsman 500 be stuck in low range any ideas?

Check the shift linkage to see if it is loose , and has gotten out of adjustment . Unhook both the high /reverse linkage and the low linkage . See if you can shift it out of gear with a pair of pliers . Then see if you can get it in high and reverse . If you can then adjust the linkage .


Has Sandra Ferguson done modeling?

No. Sandra Ferguson has stuck to acting but is a former pageant queen.


Why is my 2006 Nissan Altima gear shift stuck in park?

why is my 2006 Nissan altima gear shift stuck in park


Why would your Mazda 3 gear shift be stuck in park?

neutral safety switch/ or reverse switch faulty thanks. how would i go about replacing the safety switch? is it difficult?


I have an 89honda accord lx is stuck in reverse the gear shift moves but the car will only go in reverse please help?

sounds like the selector has broken from main boxwill require mech or someone mechanically minded to fix problem