0
How do you get the distributor to go allthe way down on a 94chevy blazer?
Wiki User
∙ 16y ago
given that you marked the relation of the distributer to the intake,you should turn the dis. counter clock appx. 3/8 inch it should lower and turn closkwise as it drops into place linning up with the mark you should have made to reinstall to its original position
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Do you unbutton a blazer when sitting down?
Usually you unbutton a blazer when you sit down because it could pull or tear. However, if your blazer is loose, you may be able to keep it buttoned.
What are the common multiples 7 and 6?
The LCM (least common multiple) is 42. But if your looking for ALLthe multiples there are a lot down the road!
How build a train in Minecraft?
ferst you have to make a raol then, go up on the hiest moiton the pot the raols allthe way down then its atrain
On 2001 4wd blazer parking brake will not stay down how do i repair it?
Having the same problem on a 02 2wd Blazer. It pulls the cables tight but will not stay down as well.
Which way does the distributor turn on 350?
if you're looking down at the distributor it rotates clockwise while running.
How to set time on 94 s10 blazer 4.3 vortex. where is the dist. bypass wire locate.?
The distributor by-pass wire, seems to be the wire that runs from the distributor to the ECM module. Just disconnect it and retime, then plug it back in. If you have checked Top Dead Center on number 1 piston then all you have to do is move the distributor cap by untightening the 9/16's bolt below the distributor housing. This will allow you to rotate the distributor with the cap on to increase or decrease the rpm's at idle. You will need to tighten the bolt holding the distributor metal plate down after Idle is running smooth or the distributor will move when the vehicle is shut off. To remove the wire from the back of the ECM (Electronic Control Module) you will need to remove the distributor cap and two connectors that run to the coil pack from the distributor.
Which way do you turn the distributor on a ford 302 to advance the timing?
Loosen the distributor hold-down bolt. Standing in front of the vehicle looking at the engine turning the distributor clockwise advances the timing. Turning the distributor counter-clockwise is retarding the timing. Hold the distributor steady while tightening the hold-down bolt. Factory hold-down bolt needs a 1/2 inch wrench.
How do you disconnect the horn to your 1999 Chevy blazer you left the sprinklers on and the window was left down to your blazer?
disconnect your neg batt cable
Where is the oil pump located on Ford F150?
Imagine a straight line directly down from the center of the distributor. The oil pump is in the bottom of the engine and straight down from the distributor.
Why Chevy blazer windows won't roll down?
The windows on a Chevy Blazer may not roll down if the power window mechanism has been damaged or broken. This can be repaired through a reputable mechanic.
How do you lock the tailgate on a 1993 blazer?
its locked while window is down.
How do you remove a distributor on a 1976 Ford 302?
Assuming you have set the engine to #1 TDC and marked the position of the distributor and the position of the rotor, remove the distributor hold-down clamp and it's bolt, then pull the distributor up and out.
