Sweet talk it! It just sits on top of the shaft splines. Grab hold of the bottom and wiggle it around while pulling upwards. LOL
It depends on what type of washer it is. If it's a GE model, and the motor / transmission is good most likely your problem is the Agitator Coupler which is located beneath the agitator If the washer is made by Whirlpool / Kenmore and the motor / transmission is good most likely your problem is the Agitator Dogs which are located inside the agitator Both are easy and inexpensive fixes
Example sentence - The agitator in the washer was not working properly until the repair man fixed it.
It means the agitator, which is the large center piece in the washer, won't churn and turn inside.
A washer uses electricity to power the motor that turns the agitator (or drum) and pumps out the water.
agitator not working
GE front loading washer does not come with a no leak guaruntee.
The agitator is part on a washer. It is driven by a couple of different methods. The first is that the agitator is splined (grooves that are cut into the metal) and they slip onto the matching splines of the agitator shaft from the transmission. The second is the use of a bell coupling which is splined to the agitator shaft as well and the agitator snaps onto the coupling.
GTW490ACJ2WS
How do i unlock an GE heavy duty washer mashine after
Whirlpool or Maytag, Maytag especially. Anything but LG
If you need your ge washer repaired you should check to see that everything is connected properly to the washer and then call a repair man, or plumber to ask his advise.
check the lid switch it is under the top of the washer and is usually activated by a pin attached to the lid of the washer