0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What kind of hydro oil does a John Deere 318 take?
john Deere 318 what oil in hydro does it take
Air gap john deere 318 electric clutch?
.18
What years did John Deere make the 318?
1952 t0 1989
What is the deck mower belt size john deere 318?
91" long, 5/8 wide
Where is the fuel pump located on a John Deere 318 lawn tractor?
Right side of engine on rear
Where can you find a wiring diagram for a john deere 318?
Diagnostics needed for john deere f510 electrical system
What could be the problem with my john deere 318 onan engine that causes it to surge when idling?
probably the governor going bad
Will a 60 inch deck from a john deere 420 work on a 318?
Not supposed to, the 318 was designed to have the 46 in or the 50 in deck on it. The 60 in decks mounting hardware that was used on the 420 is not the same. But if you can get it to work, good luck.
Does a John Deere 316 hood fit a John Deere 318?
Yes it does. Most of the hoods from the John Deere tractors of that era are interchangeable. Here's a list of the hoods that will fit the 318: 200 series: 200, 208, 210, 212, 214, 216 Early 300 series: 300, 312, 314, 316 Kohler, 317 Late 300 series: 316 Onan, 318, 322, 330, 332 400 Series: 400, 420 The hoods for the 200 and early 300 series mowers are slightly different than the hoods for the late 300 series. They will all fit a 318, but the hood used for the late 300 series uses a different type of headlight lens than the hood on the 200 and early 300 series. The hood for the 200 and early 300's has a lens that just covers the front. The hood on the late 300's wraps around the front. Hope this helps!
Is a John Deere 318 2000RPM rear PTO the same shaft size and spline number as a 6 spline 540RPM standard PTO?
No, it is not. A 2000RPM rear PTO shaft has a 1 inch by 15 spline yoke
Does the Dodge 318 have coolant drain plugs in the block?
mine has one on each side
What is fuel tank size 1994 Dakota 4wd 318?
23 gallons
