answersLogoWhite

0


Best Answer

Remove Distributor,remove drive gear,remove shaft,remove pickup coil.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change pickup coil on a 1988 GMC 2500 pick up?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change a pick up coil on a 88 GMC 2500 pickup?

how to changr pick up coil 88 vandura


What would cause a 1988 dodge d100 ignition not to fire?

change the pickup coil in distr


How do you change pickup coil on 1978 Chevy pickup?

u have to pull the whole distributer to change the pickup coil


Do you need to change your bridge pickup in your guitar if you put a dual single coil at the neck?

NO


Why 1988 Honda foreman 350 D no spark?

check the pick up coil on the left side cover of the engine they have a stator and a little box that's the pickup coil check if its damage or the ignition coil


How do you change a pickup destributor?

you must remove the distributor, disassemble unit and replace pick up coil


How voltage is induced in a permanent magnet pickup coil as the reluctor approaches alignment with the pickup coil.?

The Hall effect.


On an 86 Toyota truck what should the pickup coil resistance be?

Distributor pickup coil resistance 140-180 ohms.


How to test pickup coil 1990 chevy pickup?

hey are located inside the distributor and function as the trigger for the ignition system to produce spark. The pickup coil monitors the rotation


1993 Toyota Camry no spark motor just died you replaced timing belt tensioner and water pump with new plugs cap rotor and wires you still have no spark coil ohms good what next distributor ohms good?

You could have a bad ignitor. It is located on the drivers side fender well. There is also still a good possibility that your ignition coil is bad, despite the fact that the coil resistance is checking out within specs. I would change the coil first; it's cheaper than the ignitor or the distibutor. If still no start and you have verified that the coil is getting voltage then it is the pickup coil in the distributor. Unfortunately, the pickup coil is not replaceable on its own. You will have to change the whole distributor to get a new pickup coil. Good luck.


What are P90's on a guitar?

A type of pickup. Made by Gibson, they are a single-coil pickup.


How is voltage induced in the distributor pickup coil as the reluctor high point approaches alignment with the pickup coil?

The coil charges with electricity, and as the reluctor hits the high point, it releases all the energy at once.