0
No Job like you are asking about should be under taken without [http://www.themotorbookstore.com/chevpic.html A Repair Manual]. Because there are certain steps and pre-cautions that need to be taken and followed. Like the correct torque on the bearings after you have removed and replaced them. To much torque and they seize, not enough and they will not seat properly causing lots of Damage. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Does the 4x4 have hubs or wheel bearings?
the truck has hubs. 4x4 front wheel bearings are not serviceable.
How do you replace front wheel bearings on a Nissan frontier 4X4 1999?
How do you replace the front wheel bearings on a nissan frontier 4x4 1999
How do you replace the front bearings on a 2000 ford ranger?
Wheel bearings? 4X4 ? 4X2?
Change 1998 jimmy 4x4 front wheel bearing?
How do you change a 1998 jimmy 4X4 front wheel bearing ?
What is preload reset when replacing front wheel bearings on a 4x4?
if you find out tell me what preload is
How do you replace front wheel bearings on a 1999 Jimmy?
If it is 4x4, you have to replace the whole hub
How do you grease the front wheel bearings on a 04 3500 4X4 dodge?
They are sealed units and are not greaseable.
Do you pack the bearings on a 2002 F250 4X4?
Front wheel bearings are a sealed unit. so the answer is no. run them till you wear em out.
How do you replace the front wheel bearings on a 1997 Ford F150 4x4?
remove wheels.remove brake calipers, remove 4x4 locking hub.with special socket remove axle locking nut. brake rotor will the slide off enabling you to change bearings
How do you get the front wheel bearings off a 1995 Toyota tacoma 4x4?
don't you have a manual that can help us?
What are the torque specs on a 2004 gmc 4x4 1500 front wheel bearings?
150 FT/pnds
How do you replace front wheel bearings on a 1997 silverado 4x4?
i am pretty sure the front bearings are part of the entire hub assembly. replacing the bearings requires replacing the enitre front hub. at least that's how it was on my 97 dualie.
