it is related to Slip ring rotor max.currents and voltage ...
its depends upon rotor voltage and current
rotor contactor are used to cut the resistance in slip-ring motor connected through resistance box. resistance is proportional to torque. so by controlling rotor contactor resistance can be controlled and hence torque can be controlled. for more information check torque and speed characteristic of wound motor.
A motor with large windings will have greater shunt resistance than armature resistance due to the sheer amount of copper wire it must travel through. The gauge of the wire also plays a part in this process.
If Rotor resistance is increased torque is increased
because of high resistance in the load.
how to calculate resistance box for slipring motors
its depends upon rotor voltage and current
rotor contactor are used to cut the resistance in slip-ring motor connected through resistance box. resistance is proportional to torque. so by controlling rotor contactor resistance can be controlled and hence torque can be controlled. for more information check torque and speed characteristic of wound motor.
With a synchronous motor shorting the slip-rings together should make it work as an induction motor although perhaps not to an optimal degree.
The resistance of a motor winding is expressed in
Resistance. Water has a lot of resistance.
it is calculater by
There is no particular reason why a motor should have a bigger resistance than a bulb. A motor's resistance must depend on what current it draws at the particular voltage it was designed to run on. Equally, a bulb's resistance must depend on what current it draws at the particular voltage it was designed to run on. A particular motor may have a higher resistance than one kind of bulb but that same motor may have a lower resistance than another kind of bulb.
it is calculater by
Everything ! you calcuate it
The blower resistor controls the speeds of the blower motor Hi-resistance lower motor speed Lo-resistance higher motor speed
we can measure the resistance of the motor by using voltmeter ammeter method of by directly using a multimeter across the armature terminals of the motor in voltmeter ammeter method we should use a less value of dc voltage to find the resistance