0
what is the compression ratio and recommended gas octane?
try a higher octane fuel and see what happens, mileage may go up also.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where does the 1997 Chrysler sebring knock sensor located?
The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.
Where is the Knock Sensor located on a Chrysler Town and Country?
It is located on the side of the engine block. The purpose of the knock sensor is to retard engine timing When there is an engine noise. It is a rare case that one ever goes bad.
How many different sensors are on a Chrysler PT Cruiser engine?
Tps, map, coolant temp, cam, crank, knock,
How do you test a knock sensor on a 2002 Chrysler 300m?
With a Chrysler scan tool. Have it diagnosed at the dealer.The only way to test them would be to take it out and check to make sure it has continuity. If its has detected a knock it will put the check engine light on. If the light is on then have it scanned and see why it is on.
Does a 1969 Chrysler 300 take leaded gas?
Yes - without doubt and ran better on premium to avoid engine knock.
Location of knock sensor on 2004 Chrysler Pacifica 3.5 L engine.?
It is between the heads, under the lower intake manifold.
How do you test a 2002 Chrysler 300m knock sensor?
You can test the 2002 Chrysler 300 M knock sensor with a diagnostic tester. The diagnostic tester will tell you if the knock sensor is working.
Does the engine on a 2003 impala knock in the top of the motor if the knock sensor is bad?
The knock sensor just advances and retards the engine timing only. If there is a noise in the engine then you have engine are valve train problems. The knock sensor will not make the engine knock.
Is there a knock sensor on a 2002 Chrysler 300m?
yes
How does a modern engine management with a knock control system react to engine knock?
This is controlled by a knock sensor.
Do you need to use a timing light on a94 Chrysler LHS?
No there are no timing marks. The engine controller controls the ignition timing the input sensor is the knock sensor.
Why does your engine knock?
I have a recent engine knock on my 91 escort started out intermittant. I have a recent engine knock on my 91 escort started out intermittant.
