answersLogoWhite

0

Capacitors are rated in

Updated: 10/31/2022
User Avatar

Wiki User

8y ago

Best Answer

Typical ratings for capacitors used for general electronics applications range from a few volts to 1 kV. As the voltage increases, the dielectric must be thicker, making high-voltagecapacitors larger per capacitance than thoserated for lower voltages.

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Capacitors are rated in
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

How are motor start capacitors rated?

Motor start capacitors are rated with two main values. One is capacitance in micro farads and the other is in voltage.


Whether film capacitors can be replaced with ceramic or mica capacitor?

Film capacitors cannot be replaced with ceramic or mica capacitors if used for analog signal processing. However, mica capacitors can be replaced with ceramic capacitors in general.


Why do capacitors leak?

Mostly the leakage of capacitors is due to the resistor.


How many capacitors are use in a circuit?

Capacitors store charge. There are many applications for their use. There is no set amount of capacitors in a circuit since it is application dependent.


What is resistance start capacitor run?

most capacitors will measure infinite resistancestarting capacitors are used to set up a rotating magnetic field by phase shifting a coil in a single phase motorwhen the motor gets up to speed a centrifugal switch will disconnect the capacitorthis happens at a random time and can leave the capacitor with a charge easily 4x the applied ac voltage (+/-1,000V)so some capacitors rated as starting capacitors will have an internal bleeding resistorGas discharge lamp ballast capacitors sometimes have discharge resistors.Microwave ovens have capacitors usually in a voltage doubling configuration(+/-20,000V) most have an internal bleeding resistor.Never rely on this resistor being intact or even present.It can have fatal consequences.the internal resistors are sized to discharge the capacitors in tens of minutesTc = R * C ( seconds = ohms * farads )

Related questions

How are capacitors rated?

Capacitors are rated in Microfarads


How capacitor rated?

Capacitors are rated in Microfarads


How are motor start capacitors rated?

Motor start capacitors are rated with two main values. One is capacitance in micro farads and the other is in voltage.


What voltage must be applied to fully charge capacitors in series?

To fully charge capacitors in series, you would want to make sure they are all rated for the same voltage, and then apply the sum total of the rated voltage (if they are 25 volt caps, and you have three, then apply 75 volts). It may be worth noting here that this really is an academic exercise, since putting capacitors in series results in lower capacitance. Most often capacitors will be paralleled so a higher capacitance is attained.


Which type of a capacitor is used for power factor correction?

A.C capacitorAnswerGenerally speaking power-factor capacitors are oil-impregnated paper capacitors -i.e. capacitors whose dielectric is manufactured from oil-impregnated paper. Power-factor capacitors are rated in reactive volt amperes, rather than in farads.There is no such thing as an 'AC capacitor', as all capacitors (other than polarised capacitor) can operate on either AC or DC.


What equipment used in power factor improvement?

The simplest method of power-factor improvement is by using appropriate capacitors, connected in parallel with the load. Power-factor improvement capacitors are rated in reactive volt amperes, not farads.


Are capacitors polarity sensitive?

The capacitors those are polarity sensitive are called electrolytic and tantalum capacitors. These capacitors are labeled as positive and negative.


What is the difference between electrolytic capacitors and normal capacitors?

because normal capacitors does not have any polaririties.


Whether film capacitors can be replaced with ceramic or mica capacitor?

Film capacitors cannot be replaced with ceramic or mica capacitors if used for analog signal processing. However, mica capacitors can be replaced with ceramic capacitors in general.


How can you stop Television from humming?

Replaced capacitors that are no lomger capacitors.


What is the population of Nokian Capacitors?

Nokian Capacitors's population is 290.


When was Nokian Capacitors created?

Nokian Capacitors was created in 1957.