Yes. The roller can leave stain and make it uneven or leave lines. You should back brush to even it out. Back brushing is going over an area with a brush while the stain is wet. This brushing will even out the color and remove heavy deposits if stain. Do only a few boards at a time. Don't apply too fast.
Remember to immediately follow with a brush to even out the color and spread any heavy areas around.
A foam roller might work, but a foam pad is better. Stain is too thin to go on with a regular roller.
70 degrees
After. If you waterproof before staining, the stain won't make it to the wood to stain it.
Negative stain
we can use feulgen's method ,in which malachite green stain is used to stain the nucleus
Use a roller or staining pad to apply the oil or water-based semi-transparent stain. Go in the direction of the grain and do not allow the stain to puddle.
Yes, you can! A roller may be faster, but many pros like the deeper application afforded by using a brush.
A foam roller might work, but a foam pad is better. Stain is too thin to go on with a regular roller.
You can use a sponge applicator on a broom handle or extension
No, you should not apply urethane over deck stain. You should sand down the old deck stain first before applying any other type of finish.
It depends a lot on the type of wood you are staining. The last one I stained was made of very smooth pine planking. This was ideal for the pad and my stain went on very smoothly and quickly. I've done others where the wood was not so smooth and in thse cases a roller worked better.
Use gloves and a rag with very hot water.
Yes.
You should seal it. Maybe stain it, too.
There is two options to change your current deck to look like a redwood deck, the professional way which is a more costly option or the "DIY" way which is more labor intensive. Hardware stores like The HomeDepot, Lowes, or Ace Hardware sell a variety of different outdoor wood stains that can be used on your deck. You first have to sand your your current deck until it has reached a smooth and even surface. The stain is then poured into a painting pan and applied with a paint roller, let each coat dry FULLY and reapply coats of the stain until your desired color is reached. Good luck on your at home project!
can you stain over kool deck pool paint
Can you put stain in polyurethane to darken the color?