0
What else can I help you with?
What is the float level on a 1982 Yamaha 650 maxim?
The "dry" setting is 17.5mm +/- 1mm from the base of the carb gasket surface (without gasket) to the center of the float (furthest point from the pivot point of the float). The "wet" setting is 3mm below the gasket base of the float bowl. to accomplish this you fit a hose to the bowl drain and loop the open end to extend above the float bowl/carb surface. Open the drain screw and measure the fluid level from the bottom of the main carb body.
What is the difference in the 1984 Yamaha XT 250L and the 1984 Yamaha XT 250 LC?
Two differences are the LC has an O ring at the cylinder base in addition to the regular gasket, and the LC regular base gasket is about a quarter the cost of the L model base gasket.
Why are you getting water in your crankcase on your 1998 Suzuki RM250?
Either your head gasket or base gasket are blown
Where is the throttle body base gasket 1993 Chevy s10 pickup?
The throttle body base gasket would be located between the throttle body and the intake manifold.
How to replace gasket on oil filter base on a 1994 Mercury Cougar?
Gasket should be included with new oil filter
Is the sink leaking from the drain gasket?
To determine if the sink is leaking from the drain gasket, check for water pooling around the base of the sink. If there is water present, it may indicate a leak from the drain gasket.
What is the significance of the base ISO setting in photography?
The base ISO setting in photography is important because it determines the sensitivity of the camera sensor to light. A lower base ISO setting results in less noise and better image quality, while a higher setting can introduce more noise. Photographers often use the base ISO setting to achieve the desired balance between image quality and exposure.
2000 cavalier dies when put in gear base model runs rough then stalls in gear just replaced the plugs have run injector cleaner through it once?
I have a 2000 Chevy Cavalier also. I had the same problem, which ended up being a head gasket leak. Have a compression test done to confirm. The cylinder heads are aluminum and warp easily. Have it shaved down to make it true, then replace the head gasket. Do it yourself cost: approximately $110 for a head gasket kit. Good luck.
What is the significance of the base ISO setting in digital photography?
The base ISO setting in digital photography is important because it determines the camera's sensitivity to light. A lower base ISO setting results in less noise and better image quality, while a higher base ISO setting allows for better performance in low light conditions but may introduce more noise. Photographers often use the base ISO setting as a starting point for achieving the desired exposure and image quality in their photos.
What is the horsepower and torque of the bugatti veron?
Assuming you are talking about the 'base' model of the Veyron, the horsepower is 1,001 BHP. The torque is 1,250nm (922 lb ft).
How do i fix broken reed cage screws?
Depends which gasket it is. Could be the head gasket, which simply requires a new gasket and about 10 minutes. The base gasket is only a little more difficult to replace, and may be a good time to replase piston rings, or do a top end rebuild.
What is causing your 94 s10 to surge?
Could be a vacuum leak. Check the throttle body base gasket.
