timing chain it,s the same engine as my wifes corsa auto

up to 3 persons - 33 all round

fully loaded - 35 front 42 rear

It is directly below the front number plate in front of the radiator fan, if you look thro the bottom grill you will see where its mounted. its a but of a fiddle but with a long plane screw driver you should manage to pop it out, as usual its easyer to get out than put back in but i its only a 5 minute job and could be done by any one.

The part costs between £3 and £10 pounds online delivered.

fuel trim fault

usually caused by air leak on inlet

or maf faulty

Yes

sounds like brake fluid level is still too low or the switch on the handbrake is faulty causing the light to stay on.

-----

It could also indicate that your rotors are wearing thin.

they are 2 totally different mdels. Vectra B is from 1995 till 2002, and was upgraded in 1999.

Vectra C/Signum is the latest model from 2002 till 2008, and then you of course the newest Vectra D introduced early tis year.

with the filter 5 litres

5 litres maybe abit much ive got a c22sel veccy mine is recommended 4.4 including oil filter

1.With ignition OFF,press and hold reset button.(trip mileage,although I believe time clock on some). 2.With button still held in,switch ignition ON while continuing to hold down button. 3.After 2 seconds,InsP should flash then change to ----. 4.Release button and display reverts to trip miles.(or time?) If a Vectra "C" with Eco-flex service intervals it's slightly different. 1.Ign OFF,trip miles must show. 2.Press and hold the reset. 3.Ign ON,still holding reset,wait until service interval indicator switches over and hold on for 3 secs more. 4.After 3 seconds,the display on the instrument cluster shows the max mileage allowed between services and the timer is reset for 24 months.

its a button with a rubber cover on it. push the button. if the switch is bad then remove a bolt or two, unplug and replace. in a 1993-1997, its located in the trunk under the carpet in the left quarterpanel

There will be a tensioner pulley on the belt - loosen this first, then remove the old belt, taking careful note of where it goes. Take pictures if possible. Then put the new belt on and tighten up the tensioner until the belt is taut. Next, turn on as many high electrical load items as possible - headlights, rear windscreen demister, heater etc and start the engine. This loads the alternator, meaning the belt is under maximum tension. If the belt squeals upon starting it needs tightening. Obviously, if you can see it flapping about or vibrating a lot it needs tightened as well.

Note: the tensioner will be a pulley wheel which does not drive anything and it will have some sort of device, normally a bolt or a lever attached to a bolt, to move the wheel so that it stretches the belt when the bolt is tightened.

instrumental musi

The correct spelling is instance. The definition of instance as a noun is an example or a single occurrence of something. As a verb, instance means cite a case or face as in example.