Endocytosis - the way in which cells take in food and other materials. The cells membrane wraps around the particle it needs on its outside, ingesting it. This then becomes trapped within a vacuole inside the cells cytoplasm where it is broken down, digested, and absorbed by enzymes.
Access the starter from underneath the vehicle.
Must remove the flywheel cover because the starter must drop straigt down after its two mounting bolts have been removed.
Obtain re-activate codes and disarm the theft deterrant components including such things as the radio, and disconnect the negative battery cable.
"SAFELY raise the vehicle", (which means the wheels must be blocked, and the vehicle, is safely supported with blocks or Jack stands in the raised position.
Remove the three bolts that hold the flywheel cover on to the engine-transaxle.
Disconnect the electrical connections from the starter.
Loosen both the two bolts that hold the starter in place.
Completely remove one bolt.
Partially remove the second bolt, then support the starter.with one hand, and completely remove this bolt.
This may be an ackward thing for some, but it is possible especially when you only need to begin supporting it after the bolt has been almost completely removed.
I think its on the opposite end of the butterfly where the throttle cable goes opposite end of shaft.Sorry side of throttle body. Two torx screws.1 plug. Right above the linkage, its round and has a 2 wire connector.
Look under the vehicle along the frame rail follow the fuel line from the tank
its above the serpentine belt on the lefth hand side of the engine
Press both buttons on the "driver information center" at the same time. That should reset it for you.
Simplest is to get another good key.
If that is not available then you need to modify the wiring harness to bypass the chip reader by inserting the resistor elsewhere in the circuit.
To reset the Power Door: 1 Ignition OFF
2 Close door completely - by hand if necessary.
3 Doors unlocked
4 Power OFF at left overhead console above driver.
5 Pull fuse labelled "Tail" - it is the lower left hand blue 15A fuse in glove compartment
6 Wait at least 30 seconds
7 Replace fuse, wait 10 seconds
8 Power ON at overhead console
9 Activate 'door open' from either overhead console or door pillar switch
10 Wait 5 seconds
11 Repeat open/close sequence
Read more: 1995_transport_sliding_door_reset_after_battery_is_replace
how do you replace rear door lock assembly on 92 pONTIAC tRANSPORT
There's a solinoid in the transmission.Suggest to check that first.
Turn on interior lights. Start engine. If the lights go out when the engine stalls, you have a bad ignition switch.
If it is siezed, you must disassemble. That's the only way to avoid additional damage
To the best of my knowledge all Pontiac Transports of all years were equipped with _Fuel Injected_ 60 degree V6 engines. That being so, presumable any carburetor is located in the cargo area and is not a functional part of the vehicle.
COULD BE FAULTY TEMPERATURE GAGUE. THAT WAS THE SOLUTION FOR MY 95 TRANSPORT. COULD BE FAULTY TEMPERATURE GAGUE. THAT WAS THE SOLUTION FOR MY 95 TRANSPORT.
torque specs are lower intake 115in-ibs upper intake 18ft-lbs