0
Dodge Ram Van
The Dodge Ram Van, or Dodge B-Series, was a large van sold by the Dodge division of Chrysler Corporation. The van was launched in 1971 and continued production until 2003, when it was replaced by the Dodge Sprinter.
1,530 Questions
Where can you find a vacuum hose routing diagram for a 1986 dodge ram with a 318?
You can find a vacuum hose routing diagram for a 1986 Dodge Ram with a 318 by checking the vehicle's service manual, which often includes diagrams and specifications. Additionally, online forums dedicated to classic Dodge trucks or websites like AllDataDIY may have the information you need. You can also look for resources on automotive repair websites or YouTube, where enthusiasts often share diagrams and tutorials. Lastly, contacting a Dodge dealer or a vintage car parts supplier might yield helpful resources.
How do you replace a heater core in a 2003 ram van?
To replace the heater core in a 2003 Ram Van, start by disconnecting the negative battery cable and draining the coolant from the radiator. Remove the dashboard and any necessary components to access the heater core, including the HVAC module. Disconnect the heater core hoses from the engine bay, remove the old heater core, and install the new one. Reverse the disassembly steps, refill the coolant, and check for leaks before reconnecting the battery.
What size engine is in a 93 dodge ram van mark III?
The 1993 Dodge Ram Van Mark III typically came with a few engine options, including a 3.9-liter V6 and a 5.2-liter (318 cubic inches) V8. Additionally, a 5.9-liter (360 cubic inches) V8 engine was also available. The specific engine would depend on the exact model and configuration chosen at the time of purchase.
Where is the power steering reservoir in a 1989 Dodge 250 van?
In a 1989 Dodge 250 van, the power steering reservoir is typically located on the driver's side of the engine compartment, near the front. It is usually mounted to the engine or fender, and is identifiable by its cap, which often has a steering wheel icon. To check the fluid level, simply remove the cap and inspect the dipstick or the fluid level inside the reservoir.
What type of oil for Dodge Ram van wagon 3500?
For a Dodge Ram Van Wagon 3500, the recommended engine oil type is typically 5W-30 or 10W-30, depending on the specific engine and climate conditions. It's important to check the owner's manual for the exact specifications, as they can vary by model year and engine type. Always consider using high-quality oil that meets the API (American Petroleum Institute) standards for optimal performance and engine protection.
What causes surging in a snowblower?
Surging in a snowblower is often caused by inconsistent fuel delivery, which can result from a clogged fuel filter, a dirty carburetor, or improper fuel mixture. Additionally, air leaks in the intake system or a malfunctioning governor can lead to fluctuating engine speed. Maintaining the fuel system and ensuring proper tuning can help prevent surging. Regular maintenance, including cleaning or replacing filters and inspecting the carburetor, is essential for optimal performance.
Where is the obd plug on a 1995 dodge b2500 van located?
The OBD (On-Board Diagnostics) plug on a 1995 Dodge B2500 van is typically located under the dashboard, near the driver's side. You can usually find it above the brake pedal, close to where the steering column meets the dash. It may be necessary to remove a cover panel to access it.
Where is the flasher located on a Dodge Ram van?
The flasher on a Dodge Ram van is typically located in the fuse box. It is a small, cylindrical device that controls the flashing of the turn signals and hazard lights. The specific location can vary depending on the model year of the van, but it is commonly found near the steering column or under the dashboard. Check the owner's manual or consult a repair manual for your specific Dodge Ram van model to locate the flasher accurately.
How do you eliminate the chasis corrosion?
bolting a zink block to the chassis will greatly reduce corrosion, the zink sacrafises itself to oxydisation and preserves the parent material. This is done on large cast-iron engine blocks that are considered re-buildable.
try the cool line fitting from the radiator to the transmission i just had that problem on a 1994 mercury
Sometimes you can leak out of the tailhousing of your transmission if the housing seal is slightly damaged
THE SECURITY WILL DISABLE THE VEHICLE IF YOU LEAVE THE VEHICLE UNLOCKED OR ANY WINDOW DOWN WHILE YOU ARE AWAY FOR MORE THAN 3 MINUTES. TO RESOLVE THIS PROBLEM YOU SIMPLY NEED TO MAKE SURE ALL THE WINDOWS ARE UP AND US THE KEY FOB (REMOTE) TO LOCK AND UNLOCK THE DOOR. YOU NEED TO PLACE THE KEY INTO THE IGNITION AND TURN FORWARD TO THE ACCESSARY POSITION. THE SECURITY LIGHT WILL FLASH FOR A BREIF MOMENT, ONCE THE LIGH IS SOLID AND NOT BLINKING, YOU ARE ABLE TO START THE VEHICLE --> It could also be a faulty fuel pressure regulator, or coolant temperature sensor.
I do not know what year Honda you have, but my fuse was on the passenger side. On the end of the dash , if you open the door, there is an access panel to get to some fuses. There should be a diagram on the panel telling you where the radio fuse is located.
Where is the ignition module located on a 1989 Dodge d150 pickup truck?
The ignition module for this vehicle is mounted on the driver side fender well just below the hood hinge and behind a round vacuum diaphram.It is rectangle in shape and has a connector plug at one end(facing towards the front of the vehicle)and is mounted on a aluminum base with cooling fins(much like a small lawn mower engine)
How do you remove an alternator on a 1994 Dodge Ram van 318 V8?
go to Oreilly auto parts or other part store. Buy a Hanes manual specifically for that van and read the step by step instructions. For about $16 it will tell you how to fix anything on your van in simple and easy to read instructions.
How do you adjust the transmission on a 1993 Chevy Lumina van?
To adjust the cable, pull up the cable release at the rear of the throtle body and move the cable all the way to the rear, Then get inside the car and mash the accelerator all the way to the floor. This should adjust it.
It sounds like your wheels are out of alignment, possibly from driving hard over potholes or large bumps in the road.
How do you tighten the alternator belt on a Dodge Ram 2500 Van 5.2L V8?
Below is what I did on my 2002 Stratus 2.4L.
Note: This is a description of how I chose to repair my vehicle and should not be taken as me advising anyone in any way on how or whether they manage to repair their own vehicles.
You have to remove the passenger tire and wheel wall to do it.
1) Engaged parking brake, loosened lugs on passenger front tire.
2) Jacked-up and placed jack-stand.
3) Removed piece of black under-carriage which surrounds the oil filter and attaches to front bumper. There are at least 10 plastic push-pins to remove and I managed to destroy half of them in the process.
4) Positoned belt over lower pulleys and tensioner (as best as possible) then used a bungee to hold the top end of belt up while I worked under the car.
5) Used a 3/8 ratchet and inserted into square hole attached to the tensioner, disengaged the tensioner (moves clockwise) then used a brace to keep the ratchet handle in that position.
6) From top, removed bungee and finished placing belt over alternator, checked the position of entire belt, reengaged the tensioner, and replaced wall and wheel.
