It is the area between the engine and transmission.
The bell housing is the front part of the trans that goes around the flywheel.
The crank sensor is located on the top of the bell housing on the drivers side.
Top driver side of the bell housing.
its on the bell housing,on the tranny,driver side.towars the top,held in by one bolt.sets inside the bell housing.
The crank sensor should be on the drivers side of the transmission bell housing. It's more towards the top of the bell housing. The easiest way to get to it is reaching down from the top of the engine just below the valve cover. Atleast that is where it is on my 91 4.0L
If it is a 6 Cly. the most likely location is at about 11:00 on the bell housing looking forward. Very hard to get to and drooped bolts may end up in your transmission bell housing. Magnetic sockets and small hands advised.
On the V8 it is on the passenger side top of the transmission bell housing, on the six cylinder it is on the driver side top of the transmission bell housing.
The bell housing is between the engine and the transmission.
4.0L, driver side top of the bell housing.5.2L, passenger side top of the bell housing.4.0L, driver side top of the bell housing.5.2L, passenger side top of the bell housing.
Inside the bell housing.Inside the bell housing.
The bell housing is the front part of the transmission where it bolts to the engine. The bell housing surrounds the torque converter and flywheel.
Driver side of the bell housing at about 2 o'clock if looking from the front.
The bell housing is the end of the transmission case that bolts to the engine.
The bell housing is the front part of the trans that goes around the flywheel.The bell housing is the front part of the trans that goes around the flywheel.
The crankshaft position sensor is bolted to the bell housing of a 96 Grand Cherokee. It is at the top of the bell housing, just on the drivers side on a 4.0 L and on the passenger side on a V8.
The automatic transmission housing / case is a single casting, so the bell housing cannot be detached separately.
Top rear of bell housing.Top rear of bell housing.
The timing mark on a Fiat Punto Active Sport 2003 is through the hole of the bell housing. The bell housing is under the area of the battery of the vehicle.