4.0 inline 6: 1999 and later, 1/4-20 bolts 84 inch-lbs, 5/16-18 bolts 132 inch lbs. Or inch lbs x 0.083=ft lbs thus, 1/4-20=7 ft lbs and 5/16=11 ft lbs. 5.2 and 5.9 V8 18 ft-lbs. or ft-lbs X 12= inch lbs. 4.71 V8 132 in-lbs.
77 foot pounds
E12 external torx
No.
It is 175 ft lbs for the front wheel bearing of a grand cherokee
The knuckle could be heli-coiled if the damage is not too bad. If the stripped threads are on the caliper, replace the caliper.
The 2012 Jeep Grand-Cherokee's engine produces 260 ft-lbs. @ 4800 rpm.
00 Jeep Grand Cherokee, measurement of caliper from pin hole to pin hole.
E12 external torx
caliper bolts are the two bolts that hold a brake caliper to the caliper mounting bracket. On both the front and rear of the vehicle (unless has rear drum brakes) the bolts have rubber boots around them working as slide pins.
Front caliper bracket to knuckle, 85 ft lbs. I also use a drop of blue "Loctite" thread locker on clean threads.
Should peel off" Remove wheels Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub
Crankshaft position sensor mounting bolt.
Remove brake caliper and then caliper mounting frame . Rotor is now free.
No.
It is inside the torque converter.
It is 175 ft lbs for the front wheel bearing of a grand cherokee
No. The torque converter does not have a drain.
I have used a large "C" clamp, to compress the caliper flush to the face.