Best Answer

You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.

it's a little bit easy, you will have to watch below your dashboard, passenger side not driver side, just where the glove box is, you will have to watch one type of black cylinder holding there,right in the corner, then it has two wires , red and black, you'll have to disconnect 3 bolts and unplug the electrical connection who is a little bit upside where the motor is,then take the motor carefully, you go to autoparts store and buy new motor ONLY, once you have the old one on your hands, disconnect the clip located on the center of the filter , then pry with care (you can stick your screwdriver inside the filter with care to pull the filter off, be careful it's going to fly, mine do the same, then when you have a new motor, take the gasket out of your old one (it's your decision to buy one new gasket or discard it, i didn't buy it) place it carefully, it's easy, and then put the filter on your new motor, push it carefully, then re-attach the clip, if the model comes with "plug-style" electrical connection, just cut the wires and joint them and cover them with tape, be careful to not leave anything loose, (apparently i made it wrong and connect the electrical terminals to the plugs of the new motor, of course very poor and unsecure connection , then the car passed over a bump and disconnected itself from ground or electricity and the motor stopped and one fuse blew, for protection against electrical discharge, then i wiggled over the cables and motor worked for a seconds , then stopped, i realized my connection was bad , so be careful) ok then you will have to connect the cable to the electrical connector then put the bolts, secure the gasket, align the holes on your blower motor to place the bolts correctly, it's not as hard as it seems, then you'll have to try it out, good luck , if you need help my email is

User Avatar

Wiki User

โˆ™ 2015-07-15 19:52:39
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you change a blower motor in a 1996 Grand Cherokee Jeep?
Write your answer...
Still have questions?
magnify glass
Continue Learning about Music & Radio

Cost of a 1999 Jeep Grand Cherokee blower motor?

Sounds like an easy answer for either a dealership or a reputable parts store. I think your question is misdirected.

How do you change crank angle sensor on 2000 Jeep Grand Cherokee?


Why does your 1995 jeep grand Cherokee blower motor keep running when key is off?

your jeep is computer controlled and depending on the internal engine temp your fan may run off and on while the key is off and removed. This is normal for most vehicles today. If you mean the HVAC blower and not the engine cooling fan then you probably have a bad (shorted) power control module for the blower motor.

Where is the blower moter resister found in a 1999 Jeep Grand Cherokee limited?

The blower motor resistor block is located on the underside of the HVAC housing (Heater Box) next to the blower motor. The blower motor is located at the right side of the dashboard. You can access the blower motor resistor block from under the dashboard. A Word of Caution! Stay clear of the blower motor resistor block heat sink - It could be Hot. Incidentally, I have read about people working on their dashboards and setting off the airbag. It is a good thing to disconnect the negative battery cable from the battery and make sure that it can not touch the battery post. Wait at least a couple of minutes for the airbag system to discharge.

Does a 1995 Jeep Grand Cherokee Limited have a zero clearance motor if the timing chain breaks?


Related questions

Where is the blower motor in your 96 jeep grand Cherokee Laredo?

I mean how do you disassemble the fan blower in a 1998 Jeep Grand Cherokee Laredo. how do you remove the blower fan from the car in the Grand Jeep Cherokee Laredo.

Need location of blower motor on your 2000 grand am?

How to change blower motor on 2000 grand am gt

Where is the blower motor resistor on a 1998 jeep grand Cherokee?

The resistor is to the left of the blower, it is very hard to get to. You'll have to almost stand on your head to change it.

Why would the heater stop working in my 2001 jeep grand Cherokee?

blower motor bad or no power to it chech fuses blower switch blower motor

How do you change 2001 grand am blower motor resistor?


Where is the blower motor resistor module on 2002 Jeep Grand Cherokee?

it is under the clove box behind the blower motor you will see it if you look its a black box

What causes a blower resistor to go out on 2003 jeed grand Cherokee?

The blower motor is failing and drawing too many amps.

1995 Jeep Grand Cherokee no air blowing?

Bad Blower motor fuse Bad blower motor resistor Bad blower motor Bad switch Evaporator plugged- not allowing air flow

How do you change the blower motor resistor on a 2000 Pontiac grand am?

Please email me a photo of where the blower motor resistor is and how to change it. Thanks, Michael. By the way I want it for a 2000 Sunfire not a Grand Am.

How do you find a wiring diagram for the blower motor on a 1998 Jeep Grand Cherokee?

Air stoped coming out of vents 94 grand Cherokee how can i fix this problem?

Does blower motor run?

How do you change the head gasket on a 99 grand Cherokee?

what size motor?

People also asked