You must insert the 5 digit code. If you cannot find the code, then go to the selling dealer. They may have it on file. If not, you will have to remove the radio the get the serial # off the radio chassis. With that serial # the dealer can provide the code. There is no other way.
To remove the radio from the equinox, you first have to remvoe the bezel from around the head unit. The bezel goes from the top of the console to around the gear shift. It looks complicated to remove, but its acually pretty easy. From the bototm of the gearshift, pull up on the bezel where it meets the the verical grey plastic. There is a groove on that piece where the emergancy brake goes toward. Pull up on bezel and the clips will losen. There are a few wiring harness that connect to the AC controls and to the climate controls. Remove those and you can fully remove the bezel. Remove the screws around the stereo and pull the unit out. On the backside there are plugs for the power and antenea. Replace with a mounting kit and double din stereo and reverse the process to attach the bezel.
Contact the dealership. Most can obtain a unlock code for the factory radio.
If it's a Delco raido, go to the related link provided below, and they'll be able to get your specific unlock code for you.
pull the radio out of dash, there should be the code on top. if not go to the dlr they can get it for you
How do you reset clock radio in Chevy HHR
pay a mechanic to do it
Not on my 2006 Uplander.
Easy job on the 2002. Turn the two center air vents down and look inside above them. You will see a screw in each. Remove the screws and the face plate will come off. The radio is then bolted into the dash and can easily be removes. I hope no car radio theives are reading this!
1. Pull both side console panels off the center console. (These are by your feet in the front). 2. Remove the screw on either side that has the shifter panel attached. 3. Pull the shifter panel up at the rear and down at the front to pop it off and pull it back a little. It won't remove completely due to the shifter. 4. Remove the two screws that you just exposed below the traction control/hazard/airbag panel and disconnect the wires attached to the panel. 5. Carefully pull the trim up from around the HVAC controls and the radio. You also have to remove the center wood piece. 6. Now you can remove the screws holding the HVAC and the radio in place and pull the radio out.
There are two special tools that look like keys that are inserted to release locking tabs.
Its for installing an auxiliary audio device, like a CD changer or a satellite radio. You have to remove your radio to attach a device to it. There was no auxiliary input in the 2003 Toyota matrix and was not optional the first aux was for the 2006 matrix and up
No, this function isn't introduced until 2007. Sorry!
The bolt pattern for the Chevy Equinox is 5-115.
This is an extremely big job to remove the Heater A/C case on Chevrolet Equinox and Pontiac Torrent when there is a problem with no heat or can/t adjust temperature. ----------
134a
5w20
Unlocking the rear hatch of a 2006 Chevy Equinox. All you have to do is push the button that is inside the glove department of the car.
P235/65r16
3,500 pounds.
No it is not an interference engine.
How can I replace the climate control light on a 2006 Chevy Equinox? Both my heat control and fan speed light are out.
no the car has a timing chain
My key broke of om the inginion