It is built into the PRNDL switch on most cars and impossible to bypass.
Wiki User
∙ 2015-07-15 18:36:43Anonymous
If neither one is working, the first thing to check is your fuse. If the fuse is okay, replace the bulbs and if that doesn't work, it's probably the brake light switch. The switch is the least likely culprit though because they rarely go bad.
Any Prizm or Corolla auto trans from 93 to 97. The 1.6 or the 1.8 housings are all the same. Just make sure if it is a 3 or 4 spd auto. It is a 6 hour job.
4 quarts
I would recommend 5w-30
Under the plate in the seat of the passenger behind the driver.
where is located the oil pressure switch for 94 geo prizm
I found this switch inside the car under the dash on the wall. Look where the clutch pedal arm hits the back of the wall underneath the dash. There is a little switch that pushes in when the clutch is depressed. This can be unscrewed with a wrench and pulled out from the back and replaced. There are the electrical wires that just need to be moved to the new one. Hope that helps.
There isn't a fuel shutoff switch on General Motor's cars.
There isn't a fuel shutoff switch on General Motor's cars.
I have a 1996 Prizm LSI and the OD switch is a small round button on the side of the shift lever. You could have accidentally switched it off and that is why you get the light.
thermi housing losers
This car is not equipped with a fuel pump inertia switch.
Toyota dealer parts department.
The signal for the starter originates from the key switch, I would start there.
should be screwed into the transmission case
The switch to open the fuel filler door is on the floorboard in front of the driver's seat. Pull up.
Be sure the dash light dimmer switch is not turned off. Check the fuses.