Probably to some extent. Oil based base paint is acidic in nature, so I imagine sodium hydroxide will break it down - but you will be removing it layer-by-layer this way. Causic soda (NaOH, or Sodium Hydroxide) is a strongly alkaline solution.
Car paint is applied in a kind of large over. There is generally a base layer, and a finishing coat.
If you plan on using caustic soda, remember it is called 'caustic' for a reason. It will cause painful chemical burns to your skin on contact.
If you do come in contact with caustic soda, you should use a mild acid to neutralise it (like vinegar [ethanoic/acetic acid]) Trying to wash off caustic soda will only make matters worse.
If you want to remove car paintwork, you are best applying some kind of solvent - for example, paint stripper. Preferably one that is specifically designed for the purpose. All such products are extremely volatile, and give off strong fumes - and are probably quite nasty.
It is also possible to burn off paint, but again it probably results in toxic fumes.
For those planning on vandalising someone's car, please don't. Vandalism is the activity of a mentally deficient, mindless, sub-peasant halfwit.
Wet and dry paper is an abrasive paper that can be used with water and other liquids. This means it can sand some plastics and metals that dry paper cannot
Soda contains phosphoric acid, so it is a mild solvent. It also takes the rust off car bumpers, and I'm not kidding.
exothermic..heat is the product
You could try a bit of rubbing alcohol. It works pretty well on non-porous surfaces. If it has soaked into the surface, you may have to use a mild buffing compound, but this can have a negative effect on the overall surface and if you aren't careful you could go through the paint.
head lights, dome lights, blinkers, any light.... ABSOLUTELY NOT!!
Paintwork is the painted surface of an item, such as a car or a building.
sand will only damage paintwork if it flicks up onto the side of the car if you want to avoid this go slowly
I wax my car firstly to protect the paintwork. If I don't wax it then oxidation and weathering can irreversibly damage the paintwork to the point where no amount of wax will make it shine nicely. I have seen nasty cars with faded horrible paintwork (especially red cars for some reason) and I never want my car's paintwork to look that awful. If I go to a car wash it will come out very nice with still the protective layer of wax maintaining the paintwork underneath
It depends on what you are trying to clean off the car's paintwork. If you are trying to remove road tar yes, but WD40 will do the same and not harm the paintwork. If you must use kerosene try a small inconspicuous spot first, and wash off thoroughly with soapy water and then rinse well
you buy paint protection
sandpaper may work, power sander is faster.
spray WD-40 on the marks and they will come off not affecting the paint!
take paint brush, dip in red paint, brush over white spots ;)
To neutralize a strong acid you need a weak alkali. You've done enough damage, so I would stay away from anything that says caustic on it or you're going to end up blind or gassed. Try a box of Bicarbonate of Soda first. Or just slam it with buckets of water and dilute it.
yes used car oil can burn
To get rid of gas you just have to burn it. The car would explode if you burn the gas out of the well of my car
If a car burn at a house fire, the car will burn too and maybe cause a explosion to happen!