0
Will an engine start with 10 percent difference in cylinder psi?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is 60psi a good cylinder compression for a Chevy 283?
NO. It should start at about 150 LBS. PER cylinder. And you can't have anymore then a 15 Lb. difference in any cylinder, are the engine will idle rough.
How does a 4 cylinder engine start?
With a key, by turning on ignition
My 1965 mustang 6 cylinder 200 engine starts running rough and the motor shakes at a stop and stalls out and then its hard to start and blows out white smoke when it does start?
If white smoke is coming out of the exhaust when the engine is warmed up , it sounds like engine coolant is getting into an engine cylinder
What are the effects of a spark plug not working?
A spark plug is used to ignite the fuel/air mixture inside the cylinder of an internal combustion engine. If the spark plug isn't working, the cylinder won't fire. In a multi-cylinder engine, this will result in rough running and loss of power. In a small, single cylinder engine, this will result in the inability to start the engine.
Dose the firing order start at the front or back of the engine?
Mostly Number 1 cylinder is the frontmost cylinder. Some older cars ( Alfa's are one ) the number one cylinder is the back cylinder
How check compession engine?
With a compression gauge! Take spark plug out of cylinder 1, insert gauge into the hole start the engine take note of compression on the dial Engine off Insert the spark plug Do the same for all the other cylinder.
Why wont your 1997 ford ranger 4-cylinder start when the engine is warm?
This is probably due to the fact that you are out of gasoline, cars can't start without it. :(
Would bad key lock cylinder cause engine to run poorly?
No. It either worked to start or it didn't.
Where do you start the firing order for a dodge 5.9 liter engine?
At cylinder 1, should be labeled on distributor cap.
Engine smokes when start up and take off?
blown piston rings or valves in the cylinder head not seating properly
How do you reset timing on 1995 escort 1.9 engine after replacing cylinder head?
as long as the belt is on right it will work, start it
Why my car's engine vibrates heavily on starting in the morning?
Could be may things, excessive cylinder wall clearance(worn engine), I would start with a tune-up.
