0
Why would new lifters tap in a Chevy 350 SB after installation?
Wiki User
∙ 13y ago
perhaps the rockers aren't adjusted properly.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is the gap ratio for lifters in 1989 Chevy 350?
That would be zero valve lash. You only use a feeler gauge on solid lifters.
Can you mix a hydrulic cam with solid lifters in Chevy 350?
no
Can you adjust lifters on a 1989 Chevy 350?
It has adjustable rockers.
Does a 1989 Chevy 350 have adjustable lifters?
It has adjustable rockers.
How do you pump up the lifters on a 350 Chevy?
put the lifters up rite in a can of motor oil and let them sit for 30 mins
Does the 305 in a 1998 Chevy Silverado have roller lifters?
yes like 350 engine
How do you find the cam grind on a Chevy 350 There are no markings at the timing gear?
pull the cam and lifters
What is red line for a 1990 Chevy 350?
5,000 RPMS. If the lifters don't float out first.That would be a safe range as far as RPMS. go.
Do you have to change anything else when you change the cam in a Chevy 350?
Just the lifters and gaskets. It would me smart to replace the timing chain and gears too.
What else can cause a tapping noise in a 350 Chevy besides lifters?
Exhaust leaks, bent pushrod
How do you replace the hydraulic lifters in a 1973 to 76 Chevy 350 engine?
It's not recommended to change just the lifters. The cam and lifters should be replaced together. To get at the lifters, you can remove the rocker covers and intake manifold, loosen the rockers enough to get the pushrods out, then pull out the lifters.
What does it mean when one of my lifters is barely moving in my 1977 Chevy pickup 350?
It means the lobe is worn off of the CAM SHAFT. Need to replace cam and lifters.
