The ignition module for this vehicle is mounted on the driver side fender well just below the hood hinge and behind a round vacuum diaphram.It is rectangle in shape and has a connector plug at one end(facing towards the front of the vehicle)and is mounted on a aluminum base with cooling fins(much like a small lawn mower engine)
It is located under the hood on the center of the firewall. You will see a multi wire connector with a bolt in the center attached to the module. As I may be dealing with a dead module myself, please contact me and perhaps we can share information. (mjluneack@sbcglobal.net)
I have the same year and make of pickup. the problem is in 1988 depending on how early or how late in the year it was produced it could have 2 different ignition systems. if its a late model like mine it wont have an ignition module. late models ran a hall effects pick up in the distributor. which just relays a signal to the computer and tells it when to ground the coil to send spark to the distributor. but on the early models it should be on the fire wall or the drivers side fender well. good luck hope this helps you
On the driver side fender well or sometimes on top of the dist. cap like on my 77 Chevy
It is located on firewall. It has a 5 or 6 wire connector going to it. Usually painted orange or gold.
The engine computer, ignition module, is behind the battery in the left front fender.
bellow the intake manifold
It is part of the engine computer.
where is a ignitionmodule in a dodge colt a 1993
It is located under the hood, approximately centered on the firewall, with a lot of wires going to it.
The ignition coil should be inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
timming just needs to be close the computer adjusts it to what it needs and the points are gone since the early 70's it is electronic with moduales, sensors and such
Only one. The filter is integrated into the fuel pump module, located inside the fuel tank. To replace the filter, you must replace the entire fuel pump module. To replace that module, you must first either remove the fuel tank or the truck box.
in the computer
where is the ignition module located in my 2000 dodge 1500 ram van
The engine computer (behind the battery) is the ignition module.
The 1992 Dodge Ram 250 ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
incorparated in the pcm
where is a ignitionmodule in a dodge colt a 1993
Autozone
The engine computer is located on the passenger side of the firewall.
The ignition module for your van is located under the hood against the firewall. It has a fair size harness connected to it, with a bolt through the center of it to connect it to the module
PCM powertrain control module is located on the firewall on the passenger side. it has 3 large wire connectors.
The engine computer is the ignition module. It is the large black box under the hood.The engine computer is the ignition module. It is the large black box under the hood.
It is inside the fuel tank, part of the pump module.