Where is the neutral safety switch located on a 1996 Ford Explorer?

Answer 1

Please supply engine type/size and whether auto/manual trans. If you are talking about the manual transmission model, the switch is located on the bracket holding the clutch pedal.Since it is activated by depressing the pedal it is situated at the base of the pedal where it pivots and can be adjusted by loosening a screw in the back to make it more or less sensitive.But remember, this is a safety feature so think twice before making any changes. For the automatic model, the switch is located on the transmission case itself where the gear shifter is connected.Jack up the vehicle safely, ask a friend to move the gear shifter up and down thru park,drive, etc. and look at the side of the transmission housing: the switch is located in a plastic case where the manual gear lever causes the transmission to shift.There may be two or more wires hooked up to it.

Answer 2

The switch that prevents the starter from engaging when the transmission is not in Park or Neutral (and also turns on the backing lights when the vehicle is in reverse) is often found on the transmission case. Look there for an item that has a wiring harness that goes up to the engine compartment. There should be several wires. The switch that prevents the starter from engaging when the transmission is not in Park or Neutral (and also turns on the backing lights when the vehicle is in reverse) is often found on the transmission case. Look there for an item that has a wiring harness that goes up to the engine compartment. There should be several wires. It is in the transmission, on the valve body, called a range sensor.

Answer 3

its underneath the dash right on top of the steering column, its to the left and its white. be careful if your putting on a new one, if you slide it a little bit then you'll have your brake lights on in park. smh i know all about that haha

Technically, there is no neutral safety switch on a Chevy Van. The key is locked out of the starting position whenever the shifter is moved out of park or neutral. It is a mechanical function of the shifter, not a switch, since there are no wires connected to it.

Answer 4

It will be on the side of the automatic transmissions.

Answer 5

on the side of transmission where the shifter cable is

Answer 6

driver side of the transmission, just above the oil pan. It has three wires, and points sideways and slightly rearward.

Answer 7

drivers side on transmission just above the pan. It sits at an angle by the linkage with a 3 prong electrical connector plugged into it.

Answer 8

where is a neutral safety switch located on a Jeep grand Cherokee

Answer 9

Inside the trans, on the valve body. It is called a TRS.