1999 Galant 2.4 SOHC - Oil pressure sensor (Oil Pressure sending unit) is located at the rear of the engine block, closer to the battery. The wire harness from generator has a short branch to the oil pressure sending unit. If you remove the battery and remove the battery base plate (three 12mm + two 10mm), you can reach the oil pressure sending unit. I have Haynes manual for Galant but Haynes manual says that oil pressure sending unit for 1999 Galant 2.4 SOHC is located in front of the engine near timing belt, but its wrong information.
To replace, first pull out the slip connector. In my case, slip connector was loose when pulled out from the sensor. Prior to install slip connector, I had to remove plastic housing of the slip connector and tighten the slip connector with plyer.
Remove the sensor using 1inch deep socket. If the sensor is rusted, it is recommended to apply WD-40 before removing the sensor (If you break the sensor, it must be very hard work to remove the thread and clean the cylinder!)
You should apply liquid sealant on the sensor thread to prevent oil leakage.
Bank one usually refers to the head where cylinder number one is located. Sensor two will be the lower (rearmost) o2 in the pipe coming from bank one. This sensor will be behind the converter.
It is screwed into the exhaust system downstream (tailpipe side) of the catalytic converter.
Bank 1 sensor 1 is usually the #1 plug side and in front of the cat converter.
The 1999 Chevrolet Suburban speed sensor is located on the back of the transmission. The speed sensor will be in the upper left-hand corner.
HOW DO YOU REMOVE AND INSTALL A SPEEDOMETER SENSOR IN A 2001 FOR ESCORT ZX2,AUTO.
YES it does. It should be close to intake.
It means the bank 1 oxygen sensor is not switching like it should. Sometimes this means the sensor is bad, sometimes it means the MAF sensor is dirty. If the oxygen sensor has a lot of miles on it (more than 100,000) it's probably worn out.
Trouble code P0325 means: Knock Sensor 1 Circuit (Bank 1) Trouble code P0330 means: Knock Sensor 2 Circuit (Bank 2) Need to replace Knock sensor
Answerit's next to the oil filter
where is bank1 sensor2 on the 1999 Mitsubishi montery sport 3.5
The best way to find this out is with the users manual. You can use the diagram that is there to figure out the engine.
Where is the o2 sensor on a Mitsubishi pejero 1999, V6 GDI V75W
The bank 2, Oxygen sensor 2, on a 1999 Mitsubishi Diamante is located on the passenger side of the vehicle. It is in the exhaust in the undercarriage.
on 1999 Mitsubishi galant the transmission have stop working it don't go front or back what can I do to fix it.
where is the thermostat located on 1996 mitsubishi galant 4 cyl
yes
show me in a picture where is the starter for a 2001 mitsubshi galant
Yes it is FI
Yes.
No. Mistubishi Galant is year specific from 99-2001.