0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What are correct torque settings for 1995 Mercedes e420 wheel nuts?
What are correct torque settings for 1995 mercedes e420 wheel nuts?
Torque wrench settings for ford connect wheele nuts?
you are a nerd
What are the torque settings for rover 414 wheel nuts?
something around 110Nm
What is the torque settings for d16y5?
The torque settings for the exhaust manifold lower heater shield bolts for?æa d16y5 is 96 in - lbs. The oil pan drain plug torque settings is 29 and exhaust pipe to manifold nuts is 25.?æ
What are the torque settings for a 2000 Deawoo Lanos?
For what Bolts or Nuts?? Ask your Dealer You would get a faster answer. Good Luck.
What are the correct torque settings for Renault wheel nuts?
i dont know for sure but i would say 110 flb hope this helps
What do you torque the lug nuts to on a cat backhoe 426c?
The torque for the lug nuts on a cat backhoe 426c depend on what size the lug nuts are; for 1/2 lug nuts the torque should be around 80; for 9/16 lug nuts the torque should be around 140.
2002 Honda civic lx front wheel torque?
You mean the lug nuts? 80 foot pounds if you mean that. Most Hondas are 80 for the wheel torque
What is torque spec for front lug nuts on a GMC 1500 half ton std cab?
140 ft. pounds
What is the torque specs for the front axle on an 1986 Honda Goldwing?
Torque spec's front axel nut is 44 ft-lb caliper upper bolt 25 ft-lb and lower bolt is 17 ft-lb..............Tighten the axel holder forward nuts first, then the rear nuts. Torque is 18 ft-lb. There you go, right from the book. Good luck.
Do rod bearings torque?
Connecting rod bearing nuts are torqued. How much you should torque the nuts depends on the year, make and engine.
How do you remove lug nuts front wheel Volvo s60?
In a counter-clock-wise motion us a 19mm socket wrench to loosen. For more leverage use a Torque wrench. The torque wrench would be used to install the lugs nuts to a specified torque setting. For more leverage use a 1/2" drive breaker bar.
