0
Cable Select allows for the faster installation of additional or replacement drives. It does this by allowing the position on the cable itself to determine whether it acts as the Master or the Slave drive on an IDE channel. Thus when replacing a drive or adding a new one, the setting of the other drive is not an issue if it also set up for Cable Select support. Otherwise, one would need to know whether the other drive installed in the system was Master or Slave, so that the corresponding jumpers could be set.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the purpose of a Cable tester?
A cable tester is used to test the electrical connections in a cable or other wired device. There are two ways to test for a connection: continuity test and resistance test. A cable tester can also test for a short by determining voltage.
Reasons for Twisted the copper UTP cable?
The main purpose is to reduce cross-talk between the cable pairs. It also has the happy side effect of keeping the cable pairs neatly together while making connections..
What is the purpose of 50 ohms antenna?
A; it is to match the cable line impedance to the receiver for maximum transfer of energy
What is thermocouple cable?
The thermocouple is an sesnsing device , when the temperature increases it increases the voltage , that voltage is used for tripping purpose
What isw the Purpose of thermal conductivity in soil during cable laying?
The cabling to Earth is done for electrical conductivity, not for thermal conductivity. The general idea is to get rid of excess charges.
You can select the cable length in the option box.?
You can select the cable length in the option box.
What is the function of cable select jumper setting?
The function of cable select jumper setting is to let the cable select which drive takes priority ("master") and which one comes after ("slave").
What is the purpose of the Ctrl A shortcut key?
Select all
What is the purpose of cable puller?
The purpose of a cable puller is to allow a system of wires to pull a heavier load. A cable puller will then be used to feed the cable through on this system.
How do you select a cable size?
according to use
What is the drive nearest motherboard when using an 80-conductor cable-select cable?
Master.
When using an 80-conductor cable-select cable the drive nearest the motherboard is the?
Answer: When using an 80-conductor cable-select cable, the drive nearest the motherboard is the master, and the drive farthest from the motherboard is the slave. You can recognize a cable-select cable by a small hole somewhere in the the data cable or by labels (master or slave) on the connectors. -CompTIA A+ Guide to Hardware, Managing, Maintaining, and Troubleshooting Fifth Edition 2010 copyright - Jean Andrews, Ph.D.
Do you like to use uniforms?
i want to select a uniform for a school. do you have variety for this purpose? i want to select a uniform for a school. do you have variety for this purpose?
Why it is important to correctly rate and select a cable for the application?
Unknown
What type of committee is set up for a specific purpose?
select committee The select committee are usually set up or created for a specific purpose.
The purpose of a national convention is to select a?
presidential candidate for a political party.
What is the purpose of colored cable ties?
The purpose of using colored cable ties is to differentiate the different cables being tied. This allows the user to find a particular cable without much fuss.
