0
What is the head bolt torque and tightening pattern for an 1986 Mitsubishi Mighty Max Pick-up Truck 2.0?
Wiki User
∙ 16y ago
The cylinder head bolt torque specs for a Mitsubishi 2.0 or 2.6 is 65 to 72 ft. lbs. cold. Torque sequence is as follows.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
A wiring diagram for a 1986 Mitsubishi pickup?
coil and disribuitor elecrtic wireing?
How do you plug an ukulele into an amplifier?
You can only do that if there is a pickup installed in the ukulele. The pickup will have a standard amplifier jack in it. If there is no jack, there is no pickup!
Who invented first electric guitar pickup?
what you are asking is who invented the electric guitar. not the guitar pickup. without the pickup its just a piece of wood.
Are guitar pickup covers important on a strat?
The question was asked about pickup covers, not the pickguard, and the answer is, no, the plastic covers that go over the pickups aren't necessary, they are cosmetic, but it would sure look ugly without them.
Can you replace a bad pickup or amp on Esteban guitars?
yes, you can either put any kind of pickup in the guitar
How do you fix a stuck tailgate on a 1988 Mitsubishi Mighty Max pickup truck?
when my 89 mighty max did this I had to push the tailgate in while I opened the handle. Once open adjust or graphite the connections
Where is the fuel filter located on a 1990 Mitsubishi Mighty Max pickup truck?
Should be right next to the fuel tank underneath the truck bed.
What is the timing spec for an 1988 Mitsubishi Mighty Max pickup?
Try looking for a sticker on the underside of the hood. If it's a 2.6, it should be 8 degrees BTDC.
How do you adjust the valves on 1995 Mitsubishi mighty max pickup?
I'm no mechanic, but from what I have read, the later model engines have hydraulic lash adjusters that can be tested and replaced(Haynes manual).
The oil light in 1988 Mitsubishi mighty max pickup comes on why?
If the oil light comes on but the oil level is ok, the problem may be a faulty sending unit, as it turned out in my case.
Where is the starter located on a 1994 Mitsubishi Mighty Max pickup truck?
Get under your truck, the starter is going to be where the bellhousing of the tranny meets the motor. you'll see where it is as there will be an irregularity in the bell housing.
What is the proper tightening torque for a 1991 Toyota pickup oil drain plug?
39nm
How do you remove the pickup bed on a Mitsubishi Mighty Max?
First the gas tank will need dropped down. After doing this there are two bolts next to the cab and two bolts next to the tail gate,, take those bolts out and the bed will be free.
Is it possible to swap a 4g63 into a 1988 Mitsubishi pickup 2wd?
yes it is
1993 Mitsubishi Mighty Max pickup overheated on the highway but we got back into the city and the truck's oil is thin and seems to show water though I changed the oil and filter what can I do now?
Sounds like it may be your head gasket if that is coolant in your oil.
Where is a Mitsubishi pickup located?
Mitsubishi pickup can be found when one goes to any Mitsubishi dealers. One can get bargain deals when one visit used car shops. One can check online at sites like Auto Trader for price comparison and make a good choice.
A wiring diagram for a 1986 Mitsubishi pickup?
coil and disribuitor elecrtic wireing?
