answersLogoWhite

0


Best Answer

Its not known

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the function of a battery clip?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What does a battery clip do?

it operates a battery,mostly a 9 volt battery


Do you need a battery to see if a paper clip help light bulbs light?

Yes you do need a battery because the paper clip is usually used for an alternative for a wire and the paper clip is what the electricity travels through, so yes you do need a battery.


How to recharge a motorcycle battery?

Connect the positive clip of the battery charger to the positive terminal on the battery. Connect the negative clip of the battery charger to the negative terminal on the battery. Select the charge rate you desire either 2,4, or 6 amp. The newer battery chargers will let you know when it is fully charged.


What is the function of binder clip?

it is to clip paper so that the paper would not be flying around everywhere


Is the contact clip under the battery necessary?

yes it is necessary..


How do you get the battery out of a Volvo s40 to change it?

You have to pull a plastic clip/lever up until it pops out. That will free your battery. You may have to rock it by pushing down and pulling up to loosen the clip.


What is function of stage clip?

To hold the specimen or slide


Function of limb lamb in microscope?

it holds the clip to be not


How do you run electric lights off a battery?

Take a Energizer, Duracell, etc. battery (the bigger the bulb the bigger the battery) and a paper clip. Bend up the paper clip to a pretty straight line, and attach one end to the end of the lightbulb. Attach the other end to one end of the battery, and POOF! Light! If the bulb doesn't come on try attaching the paper clip to the other end of the battery. If it STILL doesn't work, get a bigger battery.


What function is performed by battery terminals?

The function of battery terminals is to connect a load or charger to a cell battery. Battery terminals are necessary and common in a lot of batteries.


How do you replace the battery on a 1994 BMW 318i?

It is very easy to replace the battery on a 1994 BMW 318i. The battery can be found in the trunk on the right hand side of the car. All you need to do is to use a screwdriver to take the plastic clip holding the battery in place off. After the clip is removed, take the battery out and then replace with a new one.


How do you hook the battery charger on a positive ground system?

Connect the positive clip of the charger onto the positive post of the dead battery. If the battery is located inside of a vehicle, connect the positive charger clip to a grounded surface--like an engine block--on the vehicle.