After you've installed all the bolts and tightened them until they touch, start from the center and work torwards the ends criss-crossing side to side.
The small bolts are 17 ft./lbs, the corners are 25 ft./lbs.
Tighten in three stages.
http://torquespecs.xoompages.com/gmfs70-88chv8.htm
Yes it will, it is the same bolt pattern.
< intake > 13,5,2,10
Start in the middle, and work your way out, in a circular pattern. First, go half torque, then full, turning the crankshaft by hand after each cap.
all chevy V8 are the same 18436572 in a clockwise distributor rotation when viewed from the top.
Cylinder heads are installed on a Chevy 454 big block engine by placing the gasket down on the engine block and positioning the heads over the marking tabs. The bolts are then installed and torqued to specs in sequence.
No.
It will if it was made for the Chevrolet bolt pattern.
Yes, as long as the transmission has the Chevy bolt pattern.
As long as it has the Chevy bolt pattern, yes.
No it is not completely different bolt pattern and dimensions
Yes. what is the question?- about a sm. block chevy.