0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What terminals combinations would show an open circuit if the internal overload device in a hermetic compressor should open due to excessive heat?
common to start and common to run
What causes the internal urethral sphincter to open?
Increasing urine pressure due to contraction of the full bladder
What was the purpose of operation overload?
The primary purpose of Operation Overload was to open pathways into the country. The targets were the northern and western fronts.
What is a heater overload?
overload heater is used to protect a large electric motor. If the overload heater get too hot from excessive current. its nomally-closed overload contacts wil open. interruptting the circiut of powe supply of motor
What was the primary purpose of operation overload?
The primary purpose of Operation Overload was to open pathways into the country. The targets were the northern and western fronts.
What is the device desighed to open an overload circuit and prevent overheating?
A fuse or breaker.
What component is particularly susceptible to leaks in low pressure refrigeration systems with open drive compressors?
Chiller tubes
Why do some circuits have breakers?
They are a safety mechanism designed to open or break the circuit in the case of overload. They are usually used when a device on the circuit would be damaged or destroyed by an overload.
Where do internal nostrils open?
The internal nostrils of the frog open into the frogs mouth. When the nostrils open it allows air to enter the enlarged mouth.
What component is particularly susceptible to leaks in low pressure refrigeration systems with open drive type compressors?
Chiller tubes
What happens if you overload plug sockets?
the circuit breaker will trip or fuse will blow to open the circuit.
Can you rebuild a compressor for home AC unit?
No the compressors in residential condensing units are called hermetic compressors and have to be rebuilt by cutting open the compressor shell, then rebuild the compressor and then weld the shell shut. Buy a new compressor or condensing unit.
