Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS
A Green wire (or bare wire with no insulation) is normally the local "Ground"wire.
A White wire is normally the "Neutral" wire. It is common to both hot legs on a standard 240 Volt supply.
A Black wire can be one of the two "Hot" legs of a standard 240 Volt supply or it can be the single "Hot" wire of a standard 120 Volt supply.
A Red wire can be the other of the two "Hot" legs of a standard 240 Volt supply. A Green/Yellow wire is normally the local "Earth"wire.
A Blue wire is normally the "Neutral" wire on a standard 230 Volt supply. (In the UK this may be a Black wire if the circuit was installed before 2006.)
A Brown wire is normally the "Live" wire on a standard 230 Volt supply. (In the UK this may be a Red wire if the circuit was installed before 2006.)
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized. IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
No, the electrical insulation rating of a 15 amp duplex receptacle is only rated at 130 volts. The 15 amp 240 volt receptacle is rated at 250 volts. The 240 volt receptacle also has a tandem pin configuration instead of the parallel configuration of the 120 volt device. The different pin configuration is so that a 120 volt electrical device can not be plugged into a 240 voltage receptacle.
Yes, you can always have heavier wire than code requires.
Both legs of a 240 branch circuit need to be fused with a fuse rated at 240 volts or better. The voltage potential across the load is what governs the fuse voltage ratings.
Yes, in the form of GFCI circuit breakers, not as a receptacle.
yes
Yes 220 & 240 are considered the same.
No, the electrical insulation rating of a 15 amp duplex receptacle is only rated at 130 volts. The 15 amp 240 volt receptacle is rated at 250 volts. The 240 volt receptacle also has a tandem pin configuration instead of the parallel configuration of the 120 volt device. The different pin configuration is so that a 120 volt electrical device can not be plugged into a 240 voltage receptacle.
Yes, you can always have heavier wire than code requires.
It depends on the use it is being put to. It is sufficient for a 24 volt circuit. Too much for a 12 volt circuit and too little for a 240 volt circuit.
A 20 amp 240 volt circuit can provide 4800 watts.4800 watts / 6 watt per foot = 800 feet.
Both legs of a 240 branch circuit need to be fused with a fuse rated at 240 volts or better. The voltage potential across the load is what governs the fuse voltage ratings.
Can you supply three 220 -240 volt 16.6 amp infrared heaters with one circuit?
red orange and yellow
A 240 volt street light circuit is wired in parallel connections. In the base of the street fixture an inline fuse is connected into the circuit that goes up to the fixture to protect the lamp head.
France uses 220-240 volts for their electrical system.
Question is incorrect. in a 240 Volt single phase circuit, how can you have A phase and B phase?
Yes, in the form of GFCI circuit breakers, not as a receptacle.