1st make sure your batteries are still working on the outside receiver. Then go inside and take the batteries out of your inside receiver (the clock). Put the new batteries in the clock and wait for the outside temperature to set. DO NOT SET THE TIME or anything else until the signal is received from the outside temp. If you get frustrated, take the outside transmitter inside and when it blinks the red light that is when the signal is sent, so wait for that.
Hopefully this works for you.
Temp does not display on Sharp Atomic Clock SPC 900
how do you change the day of the week? model spc1003
Press the down button on the back of the clock to go between 12 hour & 24 hour.
Your Sharp Atomic Clock will adjust automatically for DST since it receives a signal everyday to calibrate the time . See the related link below where you should be able to find the operating instructions for your model .
Atomic clock is faster than mechanical clock and it is the most accurate of all clocks in the world.
I have a 433MHz transmiitter il sale you if you wont it my email is gregory_longworth@yahoo.com
Try this (it works for a similar model): For the Sharp SPC374T Atomic Clock - Time Zone setting- Press the "Time" button once, the time zone will show where 'Day' usually is (e.g., "PA" for Pacific), use the Up or Down button to adjust. Press the time button once to save.
Try this (it works for a similar model): For the Sharp SPC374T Atomic Clock - Time Zone setting- Press the "Time" button once, the time zone will show where 'Day' usually is (e.g., "PA" for Pacific), use the Up or Down button to adjust. Press the time button once to save.
Temp does not display on Sharp Atomic Clock SPC 900
Don't no
I don't have a "Sharp" brand atomic clock but the one I do have, you need to replace the batteries in both the indoor unit AND the outdoor unit at the same time. Something to do with the proper transmission and receiving of the remote's signal with batteries of equal strength.
It is an outside temperature transmitter for a Sharp Wall Clock.
YES. My deceased had the original
how do you change the day of the week? model spc1003
Press the down button on the back of the clock to go between 12 hour & 24 hour.
Your Sharp Atomic Clock will adjust automatically for DST since it receives a signal everyday to calibrate the time . See the related link below where you should be able to find the operating instructions for your model .
Press the down button on the back of the clock to go between 12 hour & 24 hour.