0
How do you tighten up the transmission drive belt on a Murray mower?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you fit drive belt on Murray ride on mower?
We will need some more details... Is it the drive belt or the belt for the blades?it is the drive belt for Murray lawn mower model 38618x92a
What is the long belt from mower to transmission?
The belt from the mower engine to the transmission would be called a drive belt.
How do you change the clutch spring on a Murray riding lawn mower?
how to install a spring clutch on a murray mower
How do you put transmission fluid in Murray riding mower?
It does not take fluid it takes grease and unless you open it up there is no need to change
What causes a Murray riding mower from moving back and forward?
Depending on your transmission, assuming it is a gear drive and not hyrdo, the brakes could be locked on the unit, or it could be hung in gear, are you able to change gears using the gear shift ???
What is the drive belt size for a Murray 12-36 ride on mower?
its 1/2" x 83" inch od
The illustration on the drive belt routing on your john deere gt225?
i need diagram on how to replace deck belt on John Deere GT235 mower
Will Murray and mtd mower decks interchange?
No they will not.
Murray lawn mower will not prime up?
where is the primer on a murray 625 ex series
Why won't my Murray riding mower stop after the drive belt was changed?
I believe it has to do with the main drive belt. (The brake on these types of mowers are almost useless.) If the main drive belt is to short it engages the slip pulley that drives the transmission. I replaced an original belt that was bad with a replacement that was about an inch shorter and my mower would not stop. Replaced the belt again with the exact size required and problem solved ... BUT ...About a month later the same thing happened. The mower would not stop when i released the drive pedal and i ruined my transmission "snapping it out of gear to stop the mower. Now i suspect it may be a worn "slip pulley" causing the main drive belt to ride closer to the spindle on this particular pulley, this , I believe , will cause the pulley to turn faster thus engaging the transmission. This pulley is similar to an adjustable type but it "slips" . On my Troy Bilt it is located in the rear right over the transmission. Hope this helps someone because i have spent hours trying to solve this problem.
Why wont my Murray 42 inch lawn tractor move it starts and runs but wont move?
There should be a drive belt from the engine to the transmission. Make sure that it is still there and turning. If it is not, something is wrong with the transmission. Also, you may need to hold onto the bar under the handle or make a switch so that the mower will move forward.
Why does my wheel horse mower deck blades slow down when I go into grass?
Maybe you should tighten the drive belt or it could be the PTO clutch is slipping.
